Airaid 530-202 Installation Instructions

Installation Instructions

For Part Numbers:

530-202 700-452 Airaid Oiled Media Filter
531-202 701-452 SynthaMax Dry Media Filter - Red
532-202 702-452 SynthaMax Dry Media Filter - Black
533-202 703-452 SynthaMax Dry Media Filter - Blue

2006-08 Honda Ridgeline

3.5L V6

Component Identification

1. Airaid Premium Filter 1

2. Panel 1

3. Weather Strip 23” 1

4. M5x10mm Screw 4

5. Pre-Filter 1

Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.

1. Disconnect negative battery cable.
Loosen the 4 factory screws that hold the factory
air cleaner lid to the air cleaner base.

2. Remove the factory intake tube from the air
cleaner lid by pushing it towards the engine as
shown.

3. Remove the factory air cleaner lid from the
vehicle.

1”

4. Remove the factory air filter from the vehicle.

7. Install the supplied weather strip (#3) onto the

top of the Quick Fit Panel, starting at the left fend­er, and working your way towards the front of the
vehicle.

5. Install the Quick Fit Panel (#2) onto the top of
the factory air cleaner base. Align the 4 holes,
install and tighten the 4 supplied 5mm screws
(#4). Carefully slide the factory intake tube onto
the Quick Fit Panel Tube. Make sure it is installed
at least one inch onto the tube.

6. Install the Airaid Premium Filter (#1) onto the
Quick Fit Panel Tube as shown, and tighten the
clamp.

8. Double check your work!

Make sure there is no foreign material in the intake path. Make sure all clamps, hoses,
bolts, and screws are tight.

9. Reconnect the negative battery cable!

Thank you for purchasing the Airaid Intake System. Contact Airaid @ [phone] 8:00 AM - 5:00 PM MST week­days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA­TER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned periodically.

FILTER IDENTIFICATION

700-452 Airaid Oiled Media 701-452 Airaid SynthaMax Dry Media - Red

702-452 Airaid SynthaMax Dry Media - Black 703-452 Airaid SynthaMax Dry Media - Blue

For your Oiled media filter we

suggest using the AIRAID Filter

Tune-Up Kit!

Synthamax Air Filters do not require oil. Ser­vice air filter as needed by cleaning with com­mon non-petroleum all-purpose household
cleaner and water. Simple Green®, Formula
409® or equivalent works great. Apply clean­er to outside of air filter and allow to soak.
Then flush filter clean from the inside out
with a garden hose and repeat steps if neces­sary. Do not apply high pressure water or air
to clean filter. Allow filter to air dry and rein­stall.

P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray

Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 [phone] [e-mail] www.airaid.com

REV.10.28.13