Page 1
Installation Instructions
Part Number 510-621
Poweraid Spacer For
2007-14Toyota Tundra
2008-14Toyota Sequoia
5.7L V-8
2010-14 Toyota Tundra
2010-12 Toyota Sequoia
4.6L V-8
Parts List
#1 Poweraid Spacer x1
#2 Gasket x1
#3 6mm x 65mm Hex Bolts x4
#4 6mm Flat Washers x4
Tools Required For Installation
Flat Blade Screwdriver
10mm Socket
Ratchet & Extension
Pliers
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable!
Remove the engine beauty cover by lifting up on
the front, and then pulling it towards the front of
the vehicle. (Save for reuse).
2. Using a 10mm socket, loosen two hose clamps
on the factory intake tube. Slide the factory intake
tube off of the throttle body and airbox. Move the
factory intake tube aside, while leaving the factory
vacuum and breather lines connected .
Page 2
6mm Hex
Bolts
6mm Flat
Washers
Gasket
Poweraid
Spacer
3. Using pliers, squeeze the tabs on the coolant
hose clamp together. Slide the hose and clamp
towards the passenger side approximately one half
inch.
5. Re-install the factory intake tube and tighten the
hose clamps securely.
The sound of power...The “whistle” means its working!
4. Using a 10mm socket, remove the four factory
bolts on the throttle body. Gently move the throttle
body towards the passenger side of the vehicle.
Slide the Poweraid Spacer (#1) and gasket (#2)
between the throttle body and intake manifold.
Insert four 6mm x 65mm hex bolts (#3), and 6mm
flat washers (#4) thru the throttle body, gasket,
Poweraid Spacer, and into the intake manifold.
Using a 10mm socket, tighten all four throttle body
bolts evenly, to the manufacturers specifications.
Do Not Over Tighten The Bolts!
6. Re-install the engine beauty cover.
Reconnect the negative battery cable!
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
Instructions Revision
10.09.13
Loading...