Airaid 510-608 Installation Instructions

Installation Instructions
Part Number 510-608
Poweraid Spacer For
2003-09T oyota Camry 2.4L
2005-09 Scion tC 2.4L
2008-09 Scion xB 2.4L

Parts List

#1 Poweraid Spacer x1
#2 8mmx80mm Bolts x4
#3 8mm Flat Washers x4
#4 Fiber Gasket x1

Tools Required For Installation

10mm, 12mm, 13mm Sockets

Ratchet and Extension

Pliers

Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction
manual carefully before proceeding with the installation. Contact AIRAID @ [phone] 8:00 AM ­5:00 PM MST Weekdays for questions regarding fit or instructions that are not clear to you. Your
Poweraid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are miss­ing, or were damaged during shipping. If any parts are missing, please contact AIRAID.

C.

A.

B.

1. Disconnect the negative battery cable!
A). Loosen the hose clamp that holds the factory
intake tube to the air cleaner lid. B). Loosen the
two bolts that hold the lid of the air cleaner to the
base. C). Disconnect the wiring harness from the
mass air sensor.

2. Carefully remove the lid, turn it over, and pinch
the two tabs together to remove the plastic wiring
harness holder from the lid (If equipped). Now re­move the lid from the vehicle and set it aside, it will
be reinstalled later.

3. Reach down behind the engine with your pliers,
and squeeze this clamp, and remove the intake tube
from the throttle body.

4. Using a 12mm socket, remove four bolts that
hold the throttle body to the intake manifold.

Gasket

Bolts &
Washers

Spacer

5. With the gasket (#4) on top of the Poweraid

Spacer (#1), lift the throttle body up, and slide the
spacer between the manifold, and the throttle body.
Install four 8mm bolts (#2) and washers (#3) thru
the throttle body, gasket, spacer, and into the mani­fold.

7. Reinstall the intake tube and air cleaner lid. Re­connect the mass air sensor wiring harness, and
reinstall the harness holder into the air cleaner lid.
Double check your work. Make sure all clamps,
bolts, and connectors are tight.

6. Reseat the throttle body and spacer onto the
manifold, and tighten the four bolts evenly to the
manufacture’s specifications. Do Not Over Tight en
The Bolts.

8. Inspect & test the throttle linkage for full open
and closed travel before driving.

9. Re-connect the negative battery cable!

Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.

The sound of power...The “whistle” means its working!

Contact your nearest Airaid dealer for an Airaid

Intake System for your car, truck or SUV.

Instructions Revision

02/10/09