Installation Instructions
Part Number 510-607
Poweraid Spacer For
05-06 Toyota Tundra/
Sequoia 4.7L
Parts List
#1 Poweraid Spacer x1
#2 6mmx70mm Bolt x4
#3 6mm Flat Washer x4
#4 Fiber Gasket x1
Tools Required For Installation
10mm Socket
Ratchet and Extension
Vice Grip Pliers (Stud Removal)
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable!
Remove two 10mm nuts that hold the beauty cover
to the engine. Set the beauty cover and nuts aside
for re-installation later. Loosen the hose clamp that
holds the intake tube to the air filter box.
2. Loosen the hose clamp that holds the intake tube
to the throttle body. Remove and save the bolt that
holds the air conditioning line to the intake tube.
3. Disconnect the breather hose, and two vacuum
lines from the back of the intake tube. Remove the
clip from the back of the intake tube that holds the
wiring harness, these will all be re-connected later.
Remove the intake tube from the vehicle.
4. With a 10mm socket, remove three bolts and
one nut from the throttle body. Slide the throttle
body away from the intake manifold, and remove
the remaining stud.
Gasket
Spacer
5. Install the Poweraid spacer (#1) next to the intake
manifold, and the fiber gasket (#4) next to the throttle body. Insert the four provided 6mm bolts (#2),
and washers (#3), and tighten in a cross pattern, to
the vehicle manufacture’s specifications.
The sound of power...The “whistle” means its working!
6. Re-install the intake tube and tighten the hose
clamps. Re-connect the vacuum lines, wiring harness clip, and breather hose. Re-install the bolt thru
the clamp on the air conditioning hose into the intake tube. Re-install the beauty cover and nuts.
Re-connect the negative battery cable!
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.
Instructions Revision
07/12/06
Loading...