Airaid 450-636 Installation Instructions

Installation Instructions
Part Number 450-636
2011 –14 Ford Mustang
2011 –13 Ford F-150

3.7 l V-6

Note: Because of space constraints, this
Poweraid spacer can not be used in con­junction with Airaid intake system 450-265.

Parts List

#1 Poweraid Spacer x1

#2 6mmx75mm Bolt x4
#3 6mm Flat Washer x4
#4 Gasket x1
#5 Speed clamp x2
#6 3/8” x 2- 3/4” Hose x1

Tools Required For Installation

8mm, 10mm Socket

Ratchet and Extension

Pliers

Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceed-

ing with the installation. Contact AIRAID @ [phone] 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instruc-

tions that are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are

missing, or were damaged during shipping. If any parts are missing, please contact AIRAID.

B

A

C

B

1. Disconnect the negative battery cable!
A.) Disconnect the breather line or lines, from the Factory in-

take tube.
B.) loosen the clamps securing the intake tube to the throttle­body and the airbox.

C.) Remove the Factory intake tube and set aside.

2. Using pliers, open the spring clamps and slide off of the

factory breather hose, and onto the hard line.

Spacer

Gasket

3. Remove the four bolts that secure the throttlebody to the in-

take manifold and set aside. They will not be reused.

Speed Clamps

5. Remove the factory breather hose and spring clamps, and

replace them with the supplied Breather hose and Speed clamps.
Re-torque the throttlebody bolts in a X pattern, to Factory specs.

4. Position the Poweraid Spacer between the throttlebody and
the intake manifold with the supplied gasket next to the throttle­body as shown. Make sure the “flow” arrow that is printed on
the spacer is pointing towards the intake manifold. Insert the
provided bolts and washers through the throttlebody, gasket,
and Poweraid Spacer.

6. Reinstall the intake tube, tighten the two hose clamps, and
reconnect the breather line or lines.

Re-connect the negative battery cable!

The sound of power...The “whistle” means its working!

Contact your nearest Airaid dealer for an Airaid

Intake System for your car, truck or SUV.

Instructions Revision

05.22.13