Page 1
Installation Instructions
Part Number 450-613
Poweraid Spacer For
2005-10 Ford Mustang
4.0L V -6
Parts List
#1 Poweraid Spacer x1
#2 6mmx65mm Bolts x4
#3 6mm Flat Washers x4
#4 Fiber Gasket x1
Tools Required For Installation
5/16”, 10mm Sockets
Ratchet and Extension
The C.A.R.B. E.O. number for this part number
includes the vehicles listed above thru the 2009
model year. All others are pending.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully bef o re p r oc eeding with the installation. C ontact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable!
Using a 5/16” socket, loosen two hose clamps that
hold the intake tube between the throttle body, and the
air cleaner lid.
Turn the green tab, and disconnect the breather hose
from the air intake tube. Remove the intake tube from
the vehicle.
2. Using a 5/16” socket, remove the 4 bolts that hold
the throttle body to the intake manifold.
Page 2
Gasket
Spacer
Bolts &
Washers
3. Install two bolts (#2), and washers (#3) thru the
throttle body, thru the gasket (#4), thru the Poweraid
Spacer (#1), and into the intake manifold as shown.
Use caution to retain the factory o-ring gasket on
the plastic intake manifold.
Next install the remaining bolts in the bottom holes of
the throttle body, and tighten evenly to the manufacture's specifications. Do Not Over Tighten The Bolts!
The sound of power...The “whistle” means its working!
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
4. Reinstall the intake tube, and tighten the hose
clamps.
Reconnect the breather hose to the intake tube.
5. Inspect & test the throttle linkage for full open
and closed travel before driving.
6. Re-connect the negative battery cable!
Instructions Revision
02/22/10
Loading...