Page 1
Installation Instructions
Part Number 450-610
Poweraid Spacer For
2005-09 Ford Mustang GT
4.6L V -8
Parts List
#1 Poweraid Spacer x1
#2 6mmx50mm Bolts x4
#3 6mm Flat Washers x4
#4 Fiber Gasket x1
Tools Required For Installation
5/16” Deep , 10mm, Sockets
Ratchet and Extension
10mm Wrench
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully bef o re p r oc eeding with the installation. C ontact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.
Thank you for selecting AIRAID.
A.
B.
1. Disconnect the negative battery cable!
Using a 5/16” socket, loosen two hose clamps that
hold the intake tube between the throttle body, and the
air cleaner lid.
Turn the green tab, and disconnect the breather hose
from the air intake tube. Remove the tube from the
vehicle.
2. Remove beauty cover on top of intake manifold if
equipped. (2008-09)
A). Using a 5/16” deep socket, remove two studs from
the top of the throttle body.
B). Using a 10mm socket, remove two nuts from the
studs on the bottom of the throttle body.
Flip the throttle body out of the way.
Page 2
Gasket
Spacer
Bolts &
Washers
3. Using the two nuts removed in step #2, install them
as shown, on one of the studs, snug them together, and
then turn the nut closest to the manifold, and remove
the stud. Repeat the procedure on the second stud.
5. Reinstall the intake tube, and tighten the hose
clamps.
Reconnect the breather hose to the intake tube.
4. Install two bolts (#2), and washers (#3) thru the
throttle body, thru the gasket (#4), thru the Poweraid
Spacer (#1), and into the intake manifold as shown.
Use caution to retain the factory o-ring gasket on
the plastic intake manifold.
Next install the remaining bolts in the bottom holes of
the throttle body, and tighten evenly to the manufacture's specifications. Do Not Over Tighten The Bolts!
6. Inspect & test the throttle linkage for full open
and closed travel before driving. Some cruise and
kickdown cables may require adjustment. Please
refer to vehicles service manual for proper adjustment.
7. Re-connect the negative battery cable!
The sound of power...The “whistle” means its working!
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
Instructions Revision
07/15/08
Loading...