Page 1
Installation Instructions
Part Number 400-633
Poweraid Spacer For
2009-10 Ford F-150
4.6L 3-V
Parts List
#1 Poweraid Spacer x1
#2 Gasket x1
#3 6mm x 75mm Hex Bolts x4
#4 6mm Flat Washers x4
Tools Required For Installation
5/16”, 10mm Sockets
Ratchet & Extension
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully bef o re p r oc eeding with the installation. C ontact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable!
Disconnect the crankcase breather hose from the
engine air intake tube by pushing on the green tab,
and removing the hose from the nipple. Loosen the
hose clamp that secures the intake tube to the throttle body, and the one that secures the intake tube to
the airbox lid. Remove the intake tube and set aside
for now.
2. Remove the four bolts from the throttle body, and
remove the throttle body from the intake manifold,
and set it aside. There’s no need to disconnect the
wiring harness.
Page 2
Gasket
Spacer
3. Insert the four 6mm x 75mm bolts (#3) with washers
(#4) thru the throttlebody, one gasket (#2), and thru the
Poweraid Spacer (#1), and into the intake manifold.
Tighten all four throttle body bolts evenly, to the
manufacturer’s specifications. Do Not Over
Tighten The Bolts!
The sound of power...The “whistle” means its working!
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
4. Re-install the factory intake tube onto the throttle
body and the airbox lid, and tighten the hose clamps.
Re-connect the breather hose to the factory intake
tube.
Re-connect the negative battery cable!
Instructions Revision
02/11/10
Loading...