Page 1
The C.A.R.B. E. O. Number For This Spacer Does Not Include The
2010 F-150 At This Time……..It Is Pending
Installation Instructions
Part Number 400-619
Poweraid Spacer For
2007-10 Ford F-150 4.6L 2V
2007-08 Ford Explorer 4.0L
4.6L 2V motors are identified by having the
engine code W as the eighth VIN character.
(Does Not Fit 2009-10 3 Valve 4.6L F-150)
Parts List
#1 Poweraid Spacer x1
#2 Gasket x2
#3 6mm x 55mm Hex Bolts x4
#4 6mm x 75mm Hex Bolts x4
#5 6mm Flat Washers x4
Tools Required For Installation
5/16” Deep, 10mm Sockets
Ratchet & Extension
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable!
Disconnect the crankcase breather hose from the
engine air intake tube by pushing on the green tab,
and removing the hose from the nipple. Loosen the
hose clamp that holds the intake tube to the throttle
body, and slide the tube to the side to gain access to
the throttle body bolts.
2. Remove the four bolts (and/or nut and stud) from
the throttle body, and remove the throttle body from
the intake manifold, and set it aside. Retain the wiring harness anchor from the upper left stud on the
Explorer for reinstallation in step #4.
Page 2
Gasket
Spacer
Gasket
3. Remove the factory black plastic spacer that is
located between the throttle body and the intake
manifold.
5. Re-install the factory intake tube onto the throttle
body and tighten the hose clamp. Re-connect the
breather hose to the factory intake tube.
Re-connect the negative battery cable!
4. Insert four 6mm hex bolts thru the 6mm flat wash-
ers (#5). Use the 6mm x 55mm hex bolts (#3) on the
Explorer, and use the 6mm x 75mm hex bolts (#4)
on the F-150. Slide the four bolts with washers thru the
throttlebody, one gasket, the Poweraid Spacer, the other
gasket, and into the intake manifold.. Make sure to reinstall the wiring harness anchor removed in step #2, on
the Explorer. Tighten all four throttle body bolts
evenly, to the manufacturer’s specifications. Do
Not Over Tighten The Bolts!
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.
The sound of power...The “whistle” means its working!
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
Instructions Revision
07/19/12
Loading...