Page 1
Installation Instructions
Part Number 400-614
Poweraid Spacer For
05-07 Ford F 250/ F-350
6.8L V-10
Parts List
#1 Poweraid Spacer x1
#2 6mmx50mm Bolts x4
#3 6mm Flat Washers x4
#4 Fiber Gasket x1
Tools Required For Installation
8mm & 10mm Socket
Ratchet and Extension
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable!
Push the green locking tab on the factory breather
hose, and disconnect it from the intake tube. Loosen
the two hose clamps at each end of the factory intake tube. Remove the tube from the throttle body,
and the factory air cleaner, and set it aside.
2. Using a 8mm socket, remove four bolts that hold
the throttle body to the intake manifold.
Page 2
Gasket
Poweraid Spacer
Throttle Body
3. Install the supplied gasket between the throttle
body, and the Poweraid Spacer. Use caution to retain the factory o-ring in the groove on the intake
manifold. Slide two of the supplied 6mm bolts and
washers thru the top holes of the throttle body and
into the manifold.
5. Reinstall the factory intake tube onto the throttle
body, and then onto the factory air cleaner cover.
Tighten the two hose clamps, and reconnect the
breather hose.
4. Next install the remaining two bolts and washers
thru the throttle body and into the manifold. Tighten
all four bolts evenly to the manufacture’s torque
specifications.
6. Inspect & test the throttle linkage for full open
and closed travel before driving. Some cruise and
kickdown cables may require adjustment. Please
refer to vehicles service manual for proper adjustment.
7. Re-connect the negative battery cable!
The sound of power...The “whistle” means its working!
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
Instructions Revision
01/03/07
Loading...