Airaid 400-595 Installation Instructions

# 400-595 INSTALLATION INSTRUCTIONS

99-00 Ford F-250/F-350/F-550 Powerstroke 7.3L

00-03 Ford Excursion 7.3L DSL

*12/07/98 and later

Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the
instruction manual carefully before proceeding with the installat ion . Contact AIRAID @
[phone] 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or in­structions that are not clear to you. Your PowerAid Throttle Body Spacer was carefully
inspected and packaged. Check that no parts are missing, or were damaged during
shipping. If any parts are missing, please contact AIRAID.

Thank you for selecting AIRAID.

Parts List

(1) Power Plate

1

Also available for your Ford Powerstroke,

the Airaid Intake System, p/n 400-113.

Call for details!

Installation Instructions. Read Me!

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.

2. Loosen (2) hose clamps and remove rubber hose. (Ref. “C”)

3. Remove compression ring. (Ref. “B”)

4. Install power plate with a small amount of grease on the installing edge of the power plate for ease of installa-

tion. (Ref. “A”)

5. Locate the power plate midway of rubber hose making sure the power plate locks into the internal buldge of

the formed rubber hose.

6. When installing the power plate hose assembly to intake manifold, face the power plate using Figure 1.

7. Before tightening clamps, be sure that power plate has engaged both the intake manifold and formed intake

tube. * Please Note: The outside diameters of the power plate will fit inside the diameters of the intake
manifold and the formed intake tube.

The sound of power...The “whistle” means its working!

Ref. A– Power Plate Ref. D– Formed Intake Tube

Figure 1

Ref. B– Compression Ring Ref. C- Hose Clamp Assembly

Figure 1

AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 [phone] [e-mail] www.airai d.com

2

Rv. 06/06