Page 1
Installation Instructions
Part Number 350-635
2010 Dodge Challenger ,
C h arg e r, Chrysler 300C,
Jeep Cherokee SRT-8
6.1L ENGINE ONLY
Parts List
#1 Poweraid Spacer x1
#2 O-Ring x1
#3 6mm x 60mm Hex Bolts x4
#4 6mm Flat Washers x4
Tools Required For Installation
5/16” & 10mm Sockets
Ratchet & Extension
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
A
B
1. Disconnect the negative battery cable!
A) Using a 5/16” socket, loosen the hose clamp on
the throttle body end of the factory intake tube.
Move the factory intake tube up and out of the way
of the throttle body. B) Disconnect the throttle
body motor harness and the air temperature sensor.
2. Using a 10mm Socket, remove the 4 bolts that
hold the throttle body to the intake manifold.
Page 2
O-Ring
Throttle
Body
Spacer
3. Install the O-Ring (#2) into the groove on the
Poweraid Spacer (#1). Install the spacer between the
intake manifold, and the throttle body with the ORing facing the throttle body. Insert four 6mm x
60mm Hex Bolts (#3), and 6mm Flat Washers (#4)
through the throttle body, Poweraid Spacer, and into
the intake manifold. Using a 10mm socket, tighten
all 4 throttle body bolts evenly, to the manufacturer’s specifications.
Do Not Over Tighten The Bolts!
The sound of power...The “whistle” means its working!
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
4. Reinstall the factory intake tube, and tighten the
hose clamp. Reconnect the Air temperature sensor
and throttle body motor. Re-connect the negative
battery cable!
Instructions Revision
05/25/10
Loading...