Airaid 310-618 Installation Instructions

Installation Instructions Part Number 310-618 Poweraid Spacer For 2007-12 Dodge Ram & Dakota 2007-10 Dodge Nitro 2007-09 Jeep Commander 2007-09 Jeep Grand Cherokee 2007-12 Jeep Liberty 2007-09 Mitsubishi Raider
3.7L V-6
Parts List
#1 Poweraid Spacer x1 #2 Gasket x1 #3 6mm x 50mm Hex Bolts x4 #4 6mm Flat Washers x4
Tools Required For Installation
5/16” & 10mm Sockets
Ratchet & Extension
Flat Blade Screwdriver
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in­struction manual carefully before proceeding with the installation. Contact AIRAID @ (800) 498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable! 2007-10 Jeep Liberty/Dodge Nitro: Using a
5/16” socket, loosen the hose clamp on the throttle body end of the factory intake tube. Disconnect the factory temperature sensor wiring harness by slid­ing the red tab back, and then pressing the black tab on the connector while sliding it off. Slide the factory intake tube off of the throttle body.
2. All other listed vehicles: Using a 5/16” socket, or flat blade screwdriver, loosen the hose clamp which secures the factory intake tube to the resonator box. Disconnect the factory temperature sensor wiring harness from the sensor in the resonator box. Slide the factory intake tube off of the resonator box. Re­move the resonator box by pulling straight forward to release it from the throttle body and the grommet mounts. Save the resonator box for reuse.
Throttle Body
Gasket
6mm Hex Bolts 6mm Flat Washers
3. Using a 10mm socket, remove the four bolts that
secure the throttle body to the intake manifold. Next, rotate the factory throttle body out of the way to allow access to the intake manifold. Make sure the factory blue gasket is seated in the groove on the intake manifold.
5. Re-install the factory intake tube or resonator onto the vehicle. Re-connect the factory temperature sensor wiring harness. Tighten all hose clamps securely. Re-connect the negative battery cable!
Please Note: The 2010 Ram, Dakota, Nitro, and Liberty listed above are not included in the C.A.R.B. E.O. number at this time. They are pending.
4. Install the Poweraid Spacer (#1) with the bore
extending into the intake manifold. Install the Gas­ket (#2) between the Poweraid Spacer and the throt­tle body. Install four 6mm x 50mm hex bolts (#3) and 6mm flat washers (#4) through the throttle body, Poweraid Spacer, Gasket, and into the intake mani­fold. Using a 10mm socket, tighten all four throttle body bolts evenly, to the manufacturer’s specifica­tions. Do Not Over Tighten The Bolts!
Poweraid Spacer
Included with your Poweraid Spacer is a sticker with a California Air Resources Board (C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of the engine compartment. Failure to do so may prevent you from passing a smog inspection.
The sound of power...The “whistle” means its working!
Contact your nearest Airaid dealer for an Airaid Intake System
for your car, truck or SUV.
Instructions Revision
03/05/12
Loading...