Airaid 310-515 Installation Instructions

# 310-515 INSTALLATION INSTRUCTIONS

1999-2002 Jeep Grand Cherokee 4.7L

Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the
instruction manual carefully before proceeding with the installat ion . Contact AIRAID @
[phone] 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or in­structions that are not clear to you. Your Poweraid Throttle Body Spacer was carefully
inspected and packaged. Check that no parts are missing, or were damaged during
shipping. If any parts are missing, please contact AIRAID.

Thank you for selecting AIRAID.

Parts List

(1)- Power Plate

(1)- “O”-Ring #240

(3)- Hex Bolts 6mm x 60mm

(5)- Flat Washers 6mm
(2)- Air Box Extension Plates
(2)- Hex Bolts 6mm x 20mm

(3)- Throttle Bracket Extension Plates (Special)

(3)- Flat Head Screws 6mm x 20mm

1

* Also available for your Jeep Grand Cherokee–

the Airaid Intake System P/N 310-127.

Call for details!

Tools List

1/4 in. Ratchet

1/4 in. x 12 in. Extension

10mm Socket
14mm Socket

14mm Box End Wrench

3/16 Allen Wrench
5/32 Allen Wrench

7/8 Box End Wrench

Installation Instructions. Read Me!

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.

2. Remove air intake assembly.

3. Remove throttle body intake box and save bolts.

4. Remove (3) bolts from throttle body.

5. Remove bolts from throttle linkage bracket and save.

6. Install power plate using (3) 6mm x 60mm bolts and flat washers (Ref. “A”).

7. Locate (3) extension plates and (3) flat head screws before installing throttle linkage and dipstick
bracket. (* Note: Remove stud from front throttle linkage mount.) Dipstick must be located under
forward extension plate at flathead screw location (Ref. “B”).

8. Locate (2) extension plates using (2) 6mm bolts & washers to reposition throttle body intake box
using saved bolts (Step 2) & (Ref. ”C”).

9. Inspect & Test throttle linkage for full open and closed travel before driving. Some cruise or kick­down cables may require adjustment. Please refer to service manual.

10. Reinstall throttle body air intake assembly using (Step 1) as an example.

11. Reconnect battery cable. Enjoy!

The sound of power...The “whistle” means its working!

Ref. B- (3) Extension Plates (Short)

(3) 6mm Flat Head Screws

Ref. A- (1) Power Plate

(1) “O” Ring #240
(3) Bolts 6mm x 60mm
(3) Flat Washers 6mm

Ref. C- (2) Air Box Extension Plates

(2) Bolts 6mm x 20mm
(2) Flat Washers 6mm

Rev. 11-08-06

AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 [phone] [e-mail] www.airai d.com

2