Airaid 310-506 Installation Instructions

# 310-506 INSTALLATION INSTRUCTIONS

02-03 Jeep Liberty 3.7L

Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the
instruction manual carefully before proceeding with the installat ion . Contact AIRAID @
[phone] 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or in­structions that are not clear to you. Your PowerAid Throttle Body Spacer was carefully
inspected and packaged. Check that no parts are missing, or were damaged during
shipping. If any parts are missing, please contact AIRAID.

Thank you for selecting AIRAID.

Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.

Parts List

(1)- Power Plate

(1)- “O” Ring #238

(2) 1/4”ID x 3/4”OD x 1/4” O.A.L. Spacers

(1) Throttle Cable Bracket

(2) 3/8”ID x 3/4”OD x .136 O.A.L. Spacers

(1) Nutplate with 3/8-16” threads

(2) 3/8-16” x 1” Hex head bolts

1

• Also for your 02-03 Jeep Liberty 3.7L,
the Airaid Premium Stock Replacement
Filter, p/n 850-233. Call for details!

Tools List

14mm Socket

Ratchet

Flat Head Screwdriver

Installation Instructions. Read Me!

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.

2. Remove air intake hose assembly.

3. Remove throttle body air intake box.

4. Remove (3) bolts from the throttle body and save.

5. Unclip throttle & cruise cables. Remove from manifold and throttle lever.

6. Install furnished throttle & cruise cable bracket and tighten bolts. (Ref. “B”)

7. Install both throttle & cruise cables thru reinforcement ring of throttle cable bracket. Slide and lock both plas-
tic cable retainers into slot separately.

8. Install “O” ring into groove of power plate.

9. Install power plate using (3) saved bolts. (Ref. “A” and Step 4)

10. Reattach cruise and throttle cables to throttle body lever.

11. Remove (2) torque screws and reinstall with (2) 1/4” thick spacers. (Ref. “C”)

12. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise and kick down ca-
bles may require adjustment. Please refer to your vehicles service manual for proper adjustment.

13. Reinstall throttle body air intake assembly using (Step 3) as an example.

14. Reconnect battery cable. Enjoy!

The sound of power...The “whistle” means its working!

ASSEMBLY DETAIL (Ref. “B”)

Bracket

Nutplate

Ref. “C”- (2) 1/4x3/4x1/4 Spacers

(2) Spacers

Ref. “B”- (1) Throttle Cable Bracket
(2) 3/8 I.D x3/4 O.D. x .136 O.A.L. Spacers
(1) Nutplate with 3/8-16” threads
(2) 3/8-16” x 1” Hex Head Bolts

Ref. “A”- (1) Power Plate
(1) O-ring #238
(3) Saved Bolts

AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 [phone] [e-mail] www.airai d.com

2

Rev. 07/12/06