Airaid 300-944 Installation Instructions

Page 1
INSTALLATION INSTRUCTIONS
#300-944 Modular Intake Tube (MIT)
OR
#300-744 Airaid Jr. Kit
04-06 Dodge Durango 4.7L
Thank you for purchasing the Airaid MIT or Airaid Jr. Kit. Please read the instruction manual carefully before proceeding with the installation. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions that are not clear to you. Your Airaid MIT or Airaid Jr. Kit was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
Thank you for selecting Airaid.
Packing List:
KIT944T Modular Intake Tube 1
KITRDCR01 Silicone Hose Reducer 1
KITHUMPHS03 Urethane Hump Hose 1
KIT944HP Hardware & Instructions 1
- KITGRMT03 Rubber Grommet 1
- KITHS52 #52 Hose Clamp 1
- KITHS56 #56 Hose Clamp 1
- KITHS60 #60 Hose Clamp 2
Tools Required for this Installation:
Packing List (cont’d):
Flat Head Screwdriver
10mm Deep Socket
Page 2
1.
Disconnect the negative battery cable and remove the breather hose from the factory air box lid.
2.
Loosen the two hose clamps on each end of the factory intake tube.
3.
Unsnap the factory silencer box from the fan shroud and remove the factory tube assembly from the vehicle.
Installation Instructions. Read Me!
4.
Disconnect the factory electrical connector from the factory air temperature sensor.
5.
Loosen the two 10mm bolts mounting the factory air box to the intake manifold and remove from vehicle.
6.
Turn the air temperature sensor ¼ turn and remove from the air box. Retain sensor for later use.
7.
Install the reducer hose and a #52 hose clamp onto the throttle body. Install a #56 hose clamp onto the other side of the reducer.
8.
Slide the urethane hump hose onto straight end of Airaid intake tube with two #60 hose clamps.
(
Note: Leave hose clamps loose
until final assembly).
9.
Install Airaid intake tube assembly by connecting the Airaid hump hose onto the factory air box lid and the other end onto the Airaid reducer hose. Tighten all hose clamps.
Hump Hose
Page 3
10.
Install the supplied rubber grommet and factory air temperature sensor into the Airaid intake tube. Then, reconnect the factory electrical connector onto the sensor. Lastly, reconnect the factory breather hose to the air box lid.
11.
If you purchased the Airaid Jr. Kit P/N 300-744, replace the factory air filter with the Airaid Premium Filter included in the Kit.
12.
Double check your work to be certain that all nuts, bolts, and clamps are securely fastened.
13.
Reconnect the negative battery cable.
Before
After!
Page 4
m
Don’t Forget Your AIRAID Filter Tune-Up Kit!
P/N 790-550
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 AiraidInfo@airaid.com www.airaid.co
Instructions Revision
Date: 06/20/07
Loading...