Airaid 300-728 Installation Instructions

INSTALLATION INSTRUCTIONS

#300-928 Modular Intake Tube

OR

#300-728 Airaid Jr. Kit

03-07 Dodge Diesel 5.9L Modular Intake Tube

Thank you for purchasing the Airaid Modular Intake Tube. Please read the instruction manual carefully
before proceeding with the installation. Contact Airaid @ 800-498-6951 8:00 AM – 5:00 PM MST weekdays
for questions regarding fit or instructions that are not clear to you. Your Airaid Modular Intake Tube was
carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, contact Airaid.

Thank you for selecting Airaid.

Packing List:

KIT928T Modular Intake Tube 1

850-357 Airaid Premium Filter 1

Tools Required for this Installation:

Flat Head Screwdriver

7mm Socket

Installation Instructions. Read Me!

m

I DISCONNECT NEGATIVE (-) BATTERY CABLE
II Remove Factory Intake Assembly

a) Remove the electrical connector by using a flat head screwdriver to

carefully push the retaining clip away from the intake sensor. See
Fig#1

b) Loosen the hose clamp on the bottom of the factory intake tube that

connects to the turbo housing. See Fig#2

c) Unclip the factory air box lid and remove entire filter/intake

assembly from vehicle. Refer to Fig#3

d) Loosen hose clamps on the factory intake assembly above and

below the factory silencer tube. Refer to Fig#3

III Install Airaid Modular Intake Tube

a) Replace the factory silencer tube in the removed intake assembly

with the Airaid MIT using the stock hose clamps. See Fig#3 (Note:
on each side of the MIT tube are notches that must be aligned with
the notches on the stock connector tubes. Also, the flow arrow
must point down toward the turbo housing). See Fig#4

b) Install complete intake assembly onto turbo charger using the stock

hose clamps.

c) Replace the air filter box lid and re-clamp.
d) Re-connect intake sensor to the harness on the air filter box lid.

Fig#1

Fig#2

Fig#3

IV Airaid Jr. P/N 300-724 Replacement Filter

a

) If you purchased the Airaid Jr. kit P/N 300-724, replace the factory

air filter with the Airaid Premium Filter included in the Airaid Jr. kit.

IV

Finishing Up

a) Inspect overall work and be sure all clamps are securely fastened.
b) Check hood clearance.
c) Ensure that no foreign objects are in the intake path!
d) Re-connect negative battery cable.

Fig#4

Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 [phone] [e-mail] www.airaid.co