INSTALLATION INSTRUCTIONS
#300-917 Modular Intake Tube
OR
#300-717 Airaid Jr. Kit
00’-03’ Dodge Dakota / Durango 4.7L
Thank you for purchasing the Airaid Modular Intake Tube or Jr. Kit. Please read the instruction manual
carefully before proceeding with the installation. Contact Airaid @ 800-498-6951 8:00 AM – 5:00 PM MST
weekdays for questions regarding fit or instructions that are not clear to you. Your Airaid Modular Intake Tube
or Jr. Kit was carefully inspected and packaged. Check that no parts are missing, or were damaged during
shipping. If any parts are missing, contact Airaid.
Thank you for selecting Airaid.
Packing List:
KIT917T Modular Intake Tube 1
KITHUMPHS04 Urethane Hump Hose 1
KIT917HP Hardware & Instructions 1
KITHS56 #56 Hose Clamp 2
KITGRMT01 Rubber Grommet Plug 1
KITGRMT02 Rubber Grommet 1
Tools Required for this Installation:
Flat Head Screwdriver
10mm Socket
m
Installation Instructions. Read Me!
I DISCONNECT NEGATIVE (-) BATTERY CABLE
II Remove Factory Intake Assembly
a) Loosen and remove the two 10mm bolts below the silencer box.
See Fig#1
b) Loosen the hose clamp on the throttle body using a flat head
screwdriver.
c) Loosen the two clamps on the intake tube connecting the silencer
box to the filter box.
d) Remove the silencer box and accordion tube. Retain factory throttle
body coupler for reinstall of M.I.T.
III Airaid Modular Intake Tube Installation (Refer to
Fig#2)
a) Install the urethane hump hose onto larger end of the MIT tube
using the # 56 hose clamp provided.
b) Reinstall factory throttle body coupler onto smaller end of M.I.T
tube. Coupler must be orientated with the clamp screw at the 12
o’clock position.
c) Slide the MIT tube into the throttle body.
d) Align hump hose with air filter box assembly. Slide the hump hose
over end of the air filter box & secure using a #56 hose clamp.
e)
If your vehicle is equipped with an air temperature sensor, insert the
rubber grommet into the hole on the MIT and mount the air
temperature sensor into the grommet. See FIG#3
f)
If your vehicle is not equipped with an air temperature sensor,
insert the rubber grommet plug into the hole on the MIT.
IV
V Finishing Up
Airaid Jr. P/N 300-717 Replacement Filter
a) If you purchased the Airaid Jr. kit P/N 300-717, replace the
factory air filter with the Airaid Premium Filter included in the
Airaid Jr. kit.
a) Tighten all hose clamps.
b) Inspect overall work.
c) Check hood clearance.
d) Ensure that no foreign objects are in the intake path!
e) Re-connect negative battery cable.
Fig#1
Fig#2
Fig#3
Some vehicles are equipped with an
air temp. sensor.
Optional:
Airaid Intake Systems Cold Air
Dam, P/N 300-117.
See your local dealer for details
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 AiraidInfo@airaid.com www.airaid.co
Loading...