Page 1
Installation Instructions
Part Number 300-637
2011-15 Chrysler 300
2011-14 Dodge Avenger
2011-15 Dodge Charger
2011-15 Dodge Challenger
2011-14 Dodge Durango
2011-14 Jeep Grand Cherokee
2012-15 Jeep Wrangler
3.6L Pentastar V6
Parts List
#1 Poweraid Spacer x1
#2 6mmx51mm Screw x4
#3 6mm Flat Washer x4
#4 Gasket x1
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceed-
ing with the installation. Contact AIRAID @ (800) 498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instruc-
tions that are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, please contact AIRAID.
These instructions depict an installation being performed on a Dodge Challenger and
are meant to be a guide for all other makes and models listed. While specific details may vary
from vehicle to vehicle, the general install procedure remains the same.
1. Disconnect the negative battery cable!
Lift up on the engine cover to unseat it from it’s mounting
grommets, remove it from the vehicle, and set aside.
2. Disconnect the air temperature sensor from the air intake
tube, just forward of the throttle body.
Page 2
Alignment Pin
O-ring
3. Loosen the clamps on both ends of the intake tube, and re-
move from the engine compartment.
Spacer
Gasket
5. Insert the PowerAid spacer into the intake manifold. The
gasket will go between the PowerAid and the throttlebody.
4. Remove the four bolts that secure the throttlebody to the intake manifold. Without disconnecting the wiring harness, remove the throttlebody from the intake manifold and set it to the
side.
1
4
5. Reinstall the throttlebody on top of the Poweraid Spacer us-
ing the four bolts and washers that are supplied with the kit.
Tighten the bolts evenly to the vehicle manufacturers specifications, in a “X” pattern.
3
2
5. Reinstall the intake tube and engine cover in the reverse order
that they were removed. Make sure to reconnect the temperature
sensor.
Re-connect the negative battery cable!
The sound of power...The “whistle”
means its working!
Contact your nearest Airaid dealer for
an Airaid Intake System for your car,
truck or SUV.
Rev:01.13.15
Loading...