Airaid 300-117 Installation Instructions

Installation Instructions

For Part Numbers:

300-117 720-440 Airaid Oiled Media Filter
301-117 721-440 SynthaMax Dry Media Filter - Red
302-117 722-440 SynthaMax Dry Media Filter - Black
303-117 723-440 SynthaMax Dry Media Filter - Blue

2000-03 Dodge Dakota/ Durango

4.7L V8

Component Identification

1. Airaid Premium Filter 1

2. Cool Air Dam 1

3. Weather Strip 26” 1

4. Speed Clamp 1

Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.

I Disconnect the negative battery cable.

II Remove air cleaner lid.

a) Loosen the intake tube clamp at the air box lid.
b) Disconnect the crankcase breather tube at the air box lid.
c) Unclip the air box lid and remove.

III Install Airaid C.A.D.(Cool Air Dam)

a) Mount the Airaid CAD in place of the original air box lid. Snap in place.
b) Connect the intake tube to the Airaid C.A.D., and tighten the clamp.

c) Reconnect the crankcase breather tube to the nipple on the CAD tube and secure with the black speed clamp provided.

d) Install the Airaid Filter and weatherstrip onto the CAD as shown.

IV Finishing up.
a) Check over all work. Reconnect the negative battery cable.
b) Check hood clearance before closing.
c) Make sure no foreign objects are in the intake path!

Provision for Some 2003 Models:

If your vehicle is equipped with a dipstick tube that
interferes with the location of the Airaid Intake System,
an adjustment to the dipstick tube must be made. Firmly
grasp the dipstick tube about 6 inches below the top with
your left hand and carefully bend the tube towards the engine
with your right hand. This will allow for clearance of the
Airaid Intake System. Please refer to the image.

Thank you for purchasing the Airaid Intake System. Contact Airaid @ [phone] 8:00 AM - 5:00 PM MST week­days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA­TER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter is reusable and should be cleaned periodically.

FILTER IDENTIFICATION

720-440 Airaid Oiled Media 721-440 Airaid SynthaMax Dry Media - Red

722-440 Airaid SynthaMax Dry Media - Black 723-440 Airaid SynthaMax Dry Media - Blue

For your Oiled media filter

we suggest using the

AIRAID Filter Tune-Up

Kit!

Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning with
common non-petroleum all-purpose house­hold cleaner and water. Simple Green®,
Formula 409® or equivalent works great.
Apply cleaner to outside of air filter and
allow to soak. Then flush filter clean from
the inside out with a garden hose and re­peat steps if necessary. Do not apply high
pressure water or air to clean filter. Allow
filter to air dry and reinstall.

P/N 790-551 Aerosol Spray

P/N 790-550 Squeeze Spray

Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 [phone] [e-mail] www.airaid.com

REV.10.30.13