Page 1
Custom Shop
Installation Instructions
Part Number 250-927
2010-2011 Magnacharged Camaro
With Airaid Intake system
Packing List:
KIT227T Carbon Fiber Intake Tube 1
K IT250927HP Hardware & Instructions 1
KITFITTING23 Barbed PCV Fitting x1
KIT110T Zip Tie x3
Installation Note: This kit is intended to replace
the existing Intake tube on vehicles already modified and using the Airaid intake and Magnagcharger.
Technical Note. A New, vehicle specific Computer Tune is required to successfully complete this modification.
KITGRMT18 3/8” Grommet x1
Tools Required For Installation:
3/32” Allen Wrench
8, mm Socket, Ratchet & Extension, Pliers, and
Wire cutters
2. Transfer the Mass Air Flow sensor from
the Plastic Intake Tube , into the aluminum
Disconnect The Negative Battery Terminal!
1. Disconnect the breather line from the in-
take tube and unplug the Mass Air Flow
Sensor. Loosen the hose clamps and remove
the Intake tube.
meter socket in the Carbon Fiber Tube and
secure by reusing the two 8-32 x 3/8
Screws.
3. Install the 3/8” Grommet and the Barbed
Fitting into the small hole in the Intake Tube
as shown.
Page 2
4. Install The New Airaid Intake Tube
into the Hump Hose first, and then into
the Reducing Coupler. Adjust for fit, and
tighten all four hose clamps. Re connect
the Mass Airflow Sensor and secure the
wire harness to the throttlebody harness
using a single Zip Tie.
5. Install the 3/8” Breather Hose onto the
Barbed Fitting and carefully route it behind
the pulleys following the wiring harness.
6. Double check your work!
Make sure there is no foreign material in
the intake path. Make sure all clamps,
hoses, bolts, and screws are tight. Double
Connect the other end of the breather line to
the hard line from step 1. Secure the breather line behind using the two remaining Zip
Ties once you have determined it is safe from
all moving parts
check the hood clearance.
Reconnect the negative battery cable.
A Note Regarding Custom Tuning
This intake system is not calibrated to any ECU program and is not to be used without being custom tuned.
Off the shelf aftermarket REPROGRAMERS (Superchips, Hypertech e tc.) DO NOT constitute “custom tuning” .
Custom tuning is vehicle specific tuning, for that vehicle, and unique to its modifications. In other words it is ONE OFF programming. Since this tun-
ing is unique to each vehicle, AIRAID can not offer any assistance regarding any Tuning issues .
Failure to properly tune after installation of this system will result in poor performance and possible engine damage.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 AiraidInfo@airaid.com www.airaid.com
Instructions Revision
Date: 06/20/11
Loading...