Installation Instructions
#200-983 Modular Intake Tube
OR
#200-783 Airaid Jr. Kit
‘03-‘07 HUMMER H2, ‘05-‘07 Hummer SUT
Thank you for purchasing the Airaid Modular Intake Tube. Please read this instruction manual carefully
before proceeding with the installation. Contact Airaid @ 800-498-6951 8:00 AM – 5:00 PM MST weekdays
for questions regarding fit or instructions that are not clear to you. Your Airaid Modular Intake Tube was
carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact Airaid.
Thank you for selecting Airaid.
Packing List:
KIT983T Modular Intake Tube 1
720-182 Airaid Premium Filter 1
KITHUMPHS02 Urethane Hump Hose 1
KITCOUPLER02 Coupler W/ #68 Clamp 1
KITHS60 #60 Hose Clamp 2
Tools Required for this Installation:
Flat Head Screwdriver
Figure #6
Installation Instructions. Read Me!
Figure #2
Figure #5
Figure #4
Figure #3
See Local Dealer For Details.
P/N 200-183
Figure #1
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 AiraidInfo@airaid.com www.airaid.com
Rev.08.22.13
I DISCONNECT NEGATIVE (-)
BATTERY CABLE
II Remove Factory Intake Assembly
a) Remove factory filter minder and rubber
grommet and retain for re-installation.
See Fig#1
b) Loosen the factory hose clamps on each
end of the factory intake tube assembly.
See Fig #2
c) Remove the factory intake tube
assembly from vehicle. See Fig #2
III Airaid Modular Intake Tube
Installation
a) Install the provided coupler with clamp
onto the Airaid Modular Intake Tube
(MIT). See Fig #3
b) Install the urethane hump hose provided
onto the Airaid Modular Intake Tube
(MIT) with the supplied hose clamps.
(Hint: slide the hump hose all the way
onto the end of the MIT. See Fig #4
c) Install the Airaid MIT in place of the
factory intake tube assembly. See Fig
#5
d) Re-install factory filter minder and
rubber grommet into rear of Airaid MIT.
See Fig#6
e) Check for interference and adjust the
MIT accordingly, then tighten the hose
clamps.
IV Airaid Jr. P/N 200-783 Replacement
Filter
a) If you purchased the Airaid Jr. kit P/N
200-783, replace the factory air filter with
the Airaid Premium Filter included in the
Airaid Jr. kit.
V Finishing Up
a) Make sure that the intake path is clear of
debris.
b) Double check work to ensure proper fit
and that all clamps are securely fastened.
c) Re-connect negative battery cable.
Loading...