Airaid 200-712 Installation Instructions

Installation Instructions

#200-912 Modular Intake Tube

OR

#200-712 Airaid Jr. Kit

99-06/2007 “Classic” Chevy/GMC PU/SUV

4.8, 5.3, 6.0L With Mechanical Cooling Fan

Thank you for purchasing the Airaid Modular Intake Tube. Please read this instruction manual carefully
before proceeding with the installation. Contact Airaid @ 800-498-6951 8:00 AM – 5:00 PM MST weekdays
for questions regarding fit or instructions that are not clear to you. Your Airaid Modular Intake Tube was
carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact Airaid.

Thank you for selecting Airaid.

Packing List:

850-135 Airaid Premium Filter 1

KIT912T Modular Intake Tube 1

KITHUMPHS02 Urethane Hump Hose 1

KITCOUPLER02 Coupler W/ #68 Clamp 1

KITHS60 #60 Hose Clamp 2

Tools Required for this Installation:

Flat Head Screwdriver

Installation Instructions. Read Me!

m

I DISCONNECT NEGATIVE (-)

BATTERY CABLE
II Remove Factory Intake Assembly

a) Loosen the factory hose clamps on each

end of the factory intake tube assembly.

b) Using a flat head screwdriver, gently pry

the radiator hose bracket from the
factory intake tube assembly and remove
from vehicle. See Fig #1 & Fig #2

III Airaid Modular Intake Tube

Installation

a) Install the provided coupler with clamp,

onto the Airaid Modular Intake Tube
(MIT). See Fig # 3

b) Install the urethane hump hose provided

onto the Airaid Modular Intake Tube
(MIT) with the supplied hose clamps.
(Hint: slide the hump hose all the way
onto the end of the MIT. See Fig #4

c) Install the Airaid MIT in place of the

factory intake tube assembly. See Fig
#5

d) Check for interference and adjust the

MIT accordingly, then tighten the hose
clamps.

IV Airaid Jr. P/N 200-712 Replacement
Filter

a

) If you purchased the Airaid Jr. kit P/N

200-712, replace the factory air filter with
the Airaid Premium Filter included in the
Airaid Jr. kit.

V Finishing Up

a) Make sure that the intake path is clear of

debris.

b) Double check work to ensure proper fit

and that all clamps are securely fastened.

c) Re-connect negative battery cable.

Note: A Provision has been made to mount
the factory filter minder onto the MIT Intake
Tube . A 17mm hole must be drilled on the
back side of the tube. A circular impression
on the rear of the tube indicates the correct
hole location. Use the factory grommet to
mount the filter minder. See Fig #6

Figure #1 Figure #2

Figure #5

Rev. 10/11/10

Figure #4 Figure #3

Figure #6

Installation of Factory Filter Minder in

Optional:

MIT Tube

Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 [phone] [e-mail] www.airaid.co