Thank you for purchasing the Poweraid Throttle Body Spacer. Please read
the instruction manual carefully before proceeding with the installation. Contact
AIRAID @ (800) 498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regard-
ing fit or instructions that are not clear to you. Your Poweraid Throttle Body Spacer
was carefully inspected and packaged. Check that no parts are missing, or were
damaged during shipping. If any parts are missing, please contact AIRAID.
Installation Instructions
Part Number 200-630-1
2008-13 Buick Enclave
2010-15 Chevrolet Camaro
2013 Cadillac ATS
-13 Cadillac CTS
2008
3.0&3.6L
2008-09 Chevrolet Equinox Sp.
2008-11Chevrolet Malibu
2008-11 Chevrolet Traverse
2008-13 GMC Acadia
2008-09 Pontiac G6 GXP
2008-09 Pontiac G8
2008-09 Pontiac Torrent GXP
2008-09 Saturn Outlook
2008-09 Saturn Vue XR
2008-09 Suzuki XL7
3.6L V6
Parts List
#1 Poweraid Spacer x1
#2 6mmx50mm Bolt x4
#3 6mm Flat Washer x4
#4 Fiber Gasket x2
Tools Required For Installation
5/16”, 10mm Socket
These instructions depict an installation being performed on a Chevrolet Camaro and
is meant to be a guide for all other makes and models listed. While specific details may vary
from vehicle to vehicle, the general install procedure remains the same.
1. Disconnect the negative battery cable!
Remove the oil fill cap and set it aside.
Lift straight up on the front of the engine beauty cover and set it
aside.
Reinstall the oil fill cap after the beauty cover has been removed to prevent any foreign material from entering the crankcase.
2. Disconnect the breather hose elbow at the hard plastic breather tube. Loosen the two hose clamps that secure the intake tube
to the throttlebody, and the air cleaner lid.
Remove the air intake tube.
Gaskets
Spacer
3. Remove the four bolts that secure the throttlebody to the in-
take manifold. Note that the lower passenger side bolt secures a
metal bracket holding a wiring connector. Make sure to remount this bracket in the same location in step #4.
Gasket
5. Vehicles equipped with plastic intake manifolds have an O
ring pressed into the throttle body mounting surface. On these
applications only a single gasket is to be used between the spacer and the throttle body. Discard the second gasket.
4. Install the Poweraid Spacer between the throttlebody and the
intake manifold with the first supplied gasket next to the intake
manifold, and the second supplied gasket next to the throttlebody as shown. Make sure the “flow” arrow printed on the spacer is pointing towards the intake manifold.
Install the provided bolts and washers thru the throttlebody and
the Poweraid Spacer and tighten to the vehicle manufacturer's
specifications.
6. Reinstall the intake tube, tighten the two hose clamps, and
reconnect the crankcase breather tube. Reinstall the beauty cover, and oil cap in the reverse order that they were removed.
Re-connect the negative battery cable!
The sound of power...The “whistle” means its working!
Contact your nearest Airaid dealer for an Airaid
Intake System for your car, truck or SUV.
Instructions Revision
10.14.13
Loading...