# 200-584 INSTALLATION INSTRUCTIONS
99-04 Chevrolet Impala/Pontiac Grand Prix 3.8L
Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the
instruction manual carefully before proceeding with the installation. Contact AIRAID @
(800) 498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that are not clear to you. Your PowerAid Throttle Body Spacer was carefully
inspected and packaged. Check that no parts are missing, or were damaged during
shipping. If any parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
Parts List
(1) Power Plate
(2) “O” Rings
(3) 6mm x 55mm Bolts
(3) 6mm Flat Washers
(1) Support Bracket
Tools List
10mm Socket
5/32” Socket (stu d removal)
8mm Socket (to remove bracket)
1
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system.
3. Remove (3) nuts & studs from the throttle body & manifold. (Ref. “C”)
4. Remove support bracket from engine block to throttle body. (Ref. “D”)
* Please Note: When removing support bracket bolt at engine block, loosen bolt enough to remove bracket. DO NOT REMOVE BOLT.
5. Install power plate using (3) 6mm x 55mm bolts and (3) 6mm flat washers. (Ref. “C”)
* Please Note: The engraved side of plate faces the throttle body.
6. Install furnished support bracket using existing bolts. (Ref. “D”)
7. Inspect & Test throttle linkage for full open & closed travel before driving. Some cruise or kickdown cables
may require adjustment. Please refer to your vehicles service manual for proper adjusting.
8. Reinstall air intake system using Step 2 as an example.
9. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Ref. “A”- (1) Power Plate
(2) “O” Rings
Ref. “C”- (3) 6mm x 55mm Bolts
(3) 6mm Flat Washers
Ref. “B”- Throttle Body
Ref. “D”- (1) Support Bracket
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 Airaidinfo@airaid.com www.airaid.com
2
Rv. 01/04
Loading...