# 200-540 INSTALLATION INSTRUCTIONS
87-95 C/K 4.3, 5.0, 5.7L
94-95 S-10 4.3L
Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the
instruction manual carefully before proceeding with the installat ion . Contact AIRAID @
(800) 498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that are not clear to you. Your PowerAid Throttle Body Spacer was carefully
inspected and packaged. Check that no parts are missing, or were damaged during
shipping. If any parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
Parts List
(1) Power Plate
(2) Gaskets
(2) Drilled & Tapped Bolts
(1) Plain Bolt
(3) 8mm Flat Washers
Tools List
1/2” Socket
Standard Screwdriver
1
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner
3. Using 1/2” socket, remove (3) 5/16’ bolts.
* Please Note: Some units have bolts that are drilled and tapped for air cleaner mounting studs.
4. It is not necessary to remove the fuel lines.
5. Remove fuel line bracket from transmission. (Located on drivers side of bell housing)
6. Lift throttle body unit.
7. Remove gasket and clean surfaces.
8. Install power plate using (2) gaskets.
A. Locate first gasket between TBI unit and power plate.
B. Locate second gasket between power plate and manifold.
9. Install power plate using (2) drilled and tapped bolts, (1) plain bolt, and (3) 8mm flat washers. Refer to Step 3
10. Replace air cleaner studs if applicable.
11. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown cables may
require adjustment. Please refer to the vehicles service manual for proper adjustment.
12. Reinstall the air cleaner
13. Reinstall fuel line bracket. Refer to Step 5
7. Reconnect negative battery cable. Enjoy!
The sound of power...The “whistle” means its working!
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 Airaidinfo@airaid.com www.airai d.com
2
r/v 08/06
Loading...