Airaid 200-142 Installation Instructions

Installation Instructions

For Part Numbers:

200-142 700-451 Airaid Oiled Media Filter
201-142 701-451 SynthaMax Dry Media Filter - Red
202-142 702-451 SynthaMax Dry Media Filter - Black
203-142 703-451 SynthaMax Dry Media Filter - Blue

2004-07 Chevrolet Colorado/GMC Canyon
2006-07 Isuzu i-280/ i-290/ i-350/ i-370

2.8L I4, 2.9L I4 , 3.5L I5, 3.7L I5

Component Identification

1. Airaid Premium Filter 1

2. Black Front Panel 1

3. Black Back Panel 1

4. Weather Strip 23 1/2” 1

5. 6-32x 5/16” Screw 4

6. 6-32 Keps Nut 4

7. #6 Flat Washer 4

Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.

1. Disconnect negative battery cable.
Unlatch three clips that hold down the factory
airbox lid.

2. Remove the factory airbox lid, and set it
aside.

3. Remove the factory air filter, and set it
aside.

4. Install the Airaid Premium Filter (#1) on the
factory tube inside the airbox. Make sure the
hose clamp and filter, are tight against the wall
of the airbox, and tighten the clamp.

7. Make sure the second tab is aligned in the
rear slot of the factory airbox, and then adjust
the Quick Fit panels to fit squarely on top of the
airbox, and then relatch the three factory clips.

5. Assemble the Quick Fit panels (#2) using
the four 6-32x5/16” screws (#5), #6 washers
(#7), and nuts (#6).

8. Install the provided weather strip (#4) on the
top of the Quick Fit panels. For ease of installa­tion, start next to the fender and work your way
towards the front of the vehicle.

A

6. Install the Quick Fit panels by inserting the tab

on the front of the panel into the front slot of the
factory airbox base (A), and then rotating the pan­els counterclockwise.

9. Congratulations on installing your new in­take system! See the back of this page for fur­ther instructions.

10. Double check your work!

Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts, and screws are tight.

11. Reconnect the negative battery cable!

WARNING! If your vehicle has a Vehicle Emission Control Infor mation decal affixed to the factor y air box, a new r e-

placement label must be obtained and installed in a readily visible position in the engine compartment in order to remain
CARB compliant. Failure to do so will prevent the vehicle from passing a smog check. Replacement labels can be ordered
from your local dealership. Regulations state that the VECI label shall not be affixed to any equipment which is easily de­tached from the vehicle. Label placement, under the hood on a painted surface is recommended.

Thank you for purchasing the Airaid Intake System. Contact Airaid @ [phone] 8:00 AM - 5:00 PM MST week­days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA­TER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned periodically.

FILTER IDENTIFICATION

700-451 Airaid Oiled Media 701-451 Airaid SynthaMax Dry Media - Red

702-451 Airaid SynthaMax Dry Media - Black 703-451 Airaid SynthaMax Dry Media - Blue

For your Oiled media filter

we suggest using the AIRAID

Filter Tune-Up Kit!

P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray

Synthamax Air Filters do not re­quire oil. Service air filter as need­ed by cleaning with common non­petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.

Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 [phone] [e-mail] www.airaid.com

REV11.12.13