Airaid 1021 User Manual

Part Number 1021
2003-09 Mazda3 2.0L & 2.3L (nonturbo) 2003-08 Mazda6 2.0L & 2.3L (nonturbo) 2006-09 Mazda5 2.3L 2008-10* Ford Focus 2.0L 2006-09 Ford Fusion/Mercury Milan 2.3L
*2010 model is not CARB legal
Tools Required For Installation
8mm, 10mm Sockets
Ratchet and Extension
Phillips Screwdriver
#1 ECONOAID x1 #2 Gasket x1
Thank you for purchasing the ECONOAID Throttlebody Booster. Please read the instruction manual carefully before pro­ceeding with the installation. Contact ECONOAID @ (888) 876-4676 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that are not clear to you. Your ECONOAI D Throttlebody Booster was carefully inspected and pack aged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, please contact ECONOAID.
Parts List
U.S. Pat. #7,665,442
A
B
D
A
B
C
D
C
1. A.) Carefully lift straight up on the engine beauty cover and
remove it from the engine. (It is only held on by grommets.) B.) Unsnap two clips and remove the plastic battery cover. C.) Remove one plastic screw, and then remove the plastic fresh air duct (D) from the vehicle.
2. A.) Loosen the hose clamp that secures the air intake tube to the throttlebody. B.) Disconnect the crankcase breather from the air intake tube. C.) Disconnect the mass air sensor wiring connector from the mass air sensor on the air intake tube. D.) Unlatch the four clips (one on each corner) that secure the air cleaner lid to the lower airbox. Remove the air cleaner lid and flexible air intake tube from the vehicle as an assembly. Now remove the air cleaner from the lower airbox.
Fiber Gasket
ECONOAID
3. Remove the four bolts that secure the throttlebody to the
intake manifold.
5. Make sure all of the holes are aligned, and then reinstall the factory bolts and tighten them to the factory specifications. Before starting the engine, open and close the throttlebody to make sure there are no obstructions. Reinstall the intake tube, air cleaner lid, fresh air duct, battery cover, and the beauty cover in the reverse order that they were removed.
4. Pull the throttlebody away from the intake manifold. Install the ECONOAID Throttle Booster (with the logo facing the throttlebody) and the supplied gasket between the throttlebod y and the intake manifold. The gasket needs to be between the intake manifold and the ECONOAID.
6. Double check your work. Make sure there is no foreign material in the intake tract. Make sure all clamps, connectors, hoses, nuts, and bolts are secure.
Included with your ECONOAID Throttlebody
Booster is a decal with the California Air Re-
sources Board ( C.A.R.B. ) Executive Order num-
ber D-520-4. This decal must be placed in plain
view inside the engine compartment. Failure to do
may prevent you from passing a smog inspection.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
Instructions Revision
11/12/10
Loading...