Airaid 1011 User Manual

Part Number 101 1

2003-07 Dodge Ram
2003-06 Dodge Dakota
2003-06 Dodge Durango
2003-06 Mitsubishi Raider

4.7L V-8

Tools Required For Installation

5/16”, 10mm Sockets

Ratchet and Extension

#1 ECONOAID x1
#2 Gasket x1

Thank you for purchasing the ECONOAID Throttlebody Booster. Please read the instruction manual carefully before pro­ceeding with the installation. Contact ECONOAID @ [phone] 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit
or instructions that are not clear to you. Your ECONOAI D Throttlebody Booster was carefully inspected and pack aged. Check that
no parts are missing, or were damaged during shipping. If any parts are missing, please contact ECONOAID.

Parts List

U.S. Pat. #7,665,442

A

B

1. Disconnect the negative battery cable!
Using a 5/16 socket, loosen the two hose clamps that secure the
air intake tube between the airbox lid and the resonator. Re­move the tube from the vehicle. Next, squeeze the tab, and dis­connect the air intake temperature sensor wiring harness on t he
rear corner of the resonator.

A

2. A.) Using a 10mm socket, remove the two bolts that secure

the resonator to the engine. B.) Using a 5/16” socket, loosen the
hose clamp that secures the rubber coupler on the back of the
resonator to the throttlebody. Lift the front of the resonator
straight up to disengage it from the mounting grommet, and
remove the resonator assembly from the vehicle.

Fiber Gasket

ECONOAID

3. Remove the 3 bolts that secure the throttlebody to the in-

take manifold.

5. Reinstall the throttlebody onto the intake manifold and
tighten all three bolts to the vehicle manufacturer’s specifica­tions. Before starting the engine, open and close the throttle­body to make sure there are no obstructions.

7. Double check your work. Make sure there is no foreign
material in the intake tract. Make sure all clamps, connectors,
hoses, nuts, and bolts are secure.

Reconnect the negative battery cable.

4. Install the supplied gasket between the ECONOAID Throt-

tlebody Booster and the throttlebody making sure that the logo
on the ECONOAID is facing the throttlebody.

6. Reinstall the resonator and intake tube in the reverse order
that they were removed. Make sure to reconnect the air tem­perature sensor.

Included with your ECONOAID Throttlebody

Booster is a decal with the California Air Re-

sources Board ( C.A.R.B. ) Executive Order num-

ber D-520-4. This decal must be placed in plain

view inside the engine compartment. Failure to do

may prevent you from passing a smog inspection.

ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 [phone] www.ECONOAID.com

Instructions Revision

11/12/10