Part Number 1009
1996-00 Ford Crown Victoria 4.6L
1999-00 Ford Explorer XLT 4.0L SOHC
2005-09 Ford Mustang 4.0L V-6
1998-04 Ford Mustang GT 4.6L SOHC
Tools Required For Installation
5/16”, 10mm Sockets
Ratchet and Extension
#1 ECONOAID x1
#2 Gasket x2
Thank you for purchasing the ECONOAID Throttlebody Booster. Please read the instruction manual carefully before proceeding with the installation. Contact ECONOAID @ (888) 876-4676 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit
or instructions that are not clear to you. Your ECONOAI D Throttlebody Booster was carefully inspected and pack aged. Check that
no parts are missing, or were damaged during shipping. If any parts are missing, please contact ECONOAID.
Parts List
U.S. Pat. #7,665,442
1. Disconnect the negative battery cable!
Remove the air intake tube between the air filter housing and
the throttlebody.
2. Remove the four bolts that hold the throttlebody onto the
intake manifold.
ECONOAID
Fiber Gasket
1.
4.
3. Install the ECONOAID Throttlebody Booster and supplied
gasket between the throttlebody and the intake manifold with
the logo facing the front of the vehicle. Make sure that the
gasket is between the throttlebody and the ECONOAID. (If
your application does not have an O-ri ng on the int ake m an i fold, install the second supplied gasket between the
ECONOAID and the intake manifold).
5. Reinstall the intake tube and tighten the two hose clamps.
Reinstall the breather tube onto the intake tube.
3.
4. Reinstall the throttlebody onto the intake manifold using the
factory hardware. Tighten the nuts and bolts in a cross pattern
to the vehicle manufacturer’s specifications. Before starting
the engine, open and close the throttlebody to make sure there
are no obstructions.
6. Double check your work. Make sure there is no foreign material in the intake tract. Make sure all clamps, hoses, nuts, and
bolts are secure. Reconnect the negative battery cable.
Included with your ECONOAID Throttlebody Booster
is a decal with the California Air Resources Board
( C.A.R.B. ) Executive Order number D-520-4. This
decal must be placed in plain view inside the engine
compartment. Failure to do may prevent you from
passing a smog inspection.
2.
Instructions Revision
11/12/10
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
Loading...