Airaid 1008 User Manual

Part Number 1008

1987-95 GM C/K Pickup & SUV

5.0, 5.7L

Tools Required For Installation

5/16”, 1/2” Sockets

Ratchet and Extension

#1 ECONOAID x1
#2 Gasket x2

Thank you for purchasing the ECONOAID Throttlebody Booster. Please read the instruction manual carefully before pro­ceeding with the installation. Contact ECONOAID @ [phone] 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit
or instructions that are not clear to you. Your ECONOAI D Throttlebody Booster was carefully inspected and pack aged. Check that
no parts are missing, or were damaged during shipping. If any parts are missing, please contact ECONOAID.

Parts List

U.S. Pat. #7,665,442

1. Disconnect the negative battery cable!
Remove the air cleaner assembly by removing the wing nut,
disconnecting the crankcase breather hose, and the plastic
fresh air tube on the passengers side.

2. Disconnect the three vacuum lines on the front of the throt­tle body, and disconnect the throttle cable and cruise control
cables. Next remove the three bolts that secure the throttle
body to the intake manifold.

Fiber Gaskets

1.

2.

ECONOAID

3.

3. Carefully lift the throttlebody straight up and slide the

ECONOAID Throttlebody Booster with one gasket on each
side and the logo facing up, into position on top of the intake
manifold. Make sure that the bolt holes in the ECONOAID
and the two gaskets are aligned over the bolt holes in the in­take manifold, and then reinstall the throttlebody.

5. Reinstall the air cleaner and reconnect the crankcase
breather hose, and the plastic fresh air tube.

4. Reinstall the factory bolts thru the throttlebody and tighten
them to the manufacturer’s specifications. Reconnect the vac­uum hoses and throttle cables. Before starting the engine, open
and close the throttlebody to make sure that there are no ob­structions.

6. Double check your work. Make sure there is no foreign ma­terial in the intake tract. Make sure all clamps, hoses, nuts, ca­bles, and bolts are secure.

Reconnect the negative battery cable.

Included with your ECONOAID Throttlebody Booster
is a decal with the California Air Resources Board
( C.A.R.B. ) Executive Order number D-520-4. This
decal must be placed in plain view inside the engine
compartment. Failure to do may prevent you from
passing a smog inspection.

Instructions Revision

11/12/10

ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 [phone] www.ECONOAID.c om