Part Number 1005
2002-06 Cadillac Escalade 5.3L, 6.0L
2003-04 Chevrolet TrailBlazer
LT/GMC Envoy 5.3L
1996-00 Chevrolet/GMC C/K 7.4L
1997-04 Chevrolet Corvette 5.7L
1998-02 Chevrolet Camaro 5.7L
2003-04 Chevrolet SSR 5.3L
1999-06 GM Trucks and SUVs
2007 GM “Classic” Trucks
4.8L, 5.3L, 6.0L & 8.1L
2003-07 Hummer H-2 SUV& SUT
2004 Pontiac GTO 5.7L
1998-02 Pontiac Firebird 5.7L
Tools Required For Installation
5/16”, 4mm, 10mm Sockets
Ratchet and Extension
#1 ECONOAID x1
#2 Gasket x2
Thank you for purchasing the ECONOAID Throttlebody Booster. Please read the instruction manual carefully before proceeding with the installation. Contact ECONOAID @ (888) 876-4676 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit
or instructions that are not clear to you. Your ECONOAI D Throttlebody Booster was carefully inspected and pack aged. Check that
no parts are missing, or were damaged during shipping. If any parts are missing, please contact ECONOAID.
Parts List
U.S. Pat. #7,665,442
1. Disconnect the negative battery cable!
Loosen two hose clamps and remove the air intake tube. Separate the intake tube from the plastic clamp on the upper radiator hose. (If equipped).
2. Using a 10mm socket, remove the three nuts that hold the
throttlebody to the intake manifold.
Fiber Gasket
ECONOAID
3. Using a 4mm socket, remove the three studs that go thru the
throttlebody into the intake manifold
5. Now reinstall the three studs, and nuts and tighten them to
the manufacturer’s specifications. Before starting the engine,
open and close the throttlebody to make sure there are no obstructions.
4. Pull the throttlebody towards you and install the
ECONOAID Throttlebody Booster against the intake manifold with the logo facing the throttlebody. Next install the
supplied gasket against the throttlebody. Make sure the holes
in the gasket align with the holes in the ECONOAID. (If your
vehicle does not have an O-ring in the face of the intake manifold, install the second supplied gasket between the
ECONOAID and the manifold).
6. Reinstall the intake tube and tighten the two hose clamps.
Next, reattach the intake tube to the radiator hose via the plastic clamp. (If equipped)
7. Double check your work. Make sure there is no foreign material in the intake tract. Make sure all clamps, connectors,
hoses, nuts, and bolts are secure.
Reconnect the negative battery cable.
Included with your ECONOAID Throttlebody
Booster is a decal with the California Air Re-
sources Board ( C.A.R.B. ) Executive Order
number D-520-4. This decal must be placed in
plain view inside the engine compartment.
Failure to do may prevent you from passing a
smog inspection.
Instructions Revision
03/21/11
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
Loading...