Airaid 1001 User Manual

Part Number 1001

2007-13 * Chevrolet Silverado
GMC Sierra
2009-14 Cadillac SUV & SUT
GMT-900 Trucks & SUVs
2005-13* Corvette
2009-12* Chevrolet Colorado
2005-06 Chevrolet SSR 6.0L
2005-09 Chevrolet Trailblazer
2005-09 GMC Envoy
2009-12 GMC Canyon
2008-09 Hummer H-2
2008-09 Hummer H-3 Alpha
2005-06 Pontiac GTO
2010–15* Chevrolet Camaro

4.8L, 5.3L, 6.0L, 6.2L Engines

Tools Required For Installation

5/16”, 10mm Sockets

Ratchet and Extension

#1 ECONOAID x1
#2 Gasket x1

Thank you for purchasing the ECONOAID Throttlebody Booster. Please read the instruction manual carefully before pro­ceeding with the installation. Contact ECONOAID @ [phone] 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit
or instructions that are not clear to you. Your ECONOAID Throttlebody Booster was carefully inspected and packaged. Check that
no parts are missing, or were damaged during shipping. If any parts are missing, please contact ECONOAID.

Parts List

U.S. Pat. #7,665,442

1. Disconnect the negative battery cable!
Lift up on the front of the and beauty cover and remove it
from the vehicle. Push down on the radiator hose, and sepa­rate the intake tube from the plastic clamp.

2. Disconnect the breather tube from the intake tube, by gently
pulling towards you. An O-ring is all that holds it in place.

3. Next loosen the hose clamp on the intake tube at the throttle
body, and at the Mass Air Sensor, and then remove the tube
from the vehicle.

4. With a 10mm socket remove the two nuts, and the two bolts
that hold the throttle body to the intake manifold. Without
disconnecting the wiring harness, set the throttle body aside.

Fiber Gasket

5. Install the ECONOAID Throttlebody Booster against the

manifold over the studs with the logo facing the throttlebody.
Next install the supplied gasket against the ECONOAID.

7. Reinstall the intake tube and tighten the two hose clamps.
Next, reattach the intake tube to the radiator hose via the plas­tic clamp. Reinstall the breather tube into the intake tube. Re­install the beauty cover.

ECONOAID

1.

4.

3.

2.

6. Reinstall the throttlebody onto the intake manifold using the

factory hardware. Tighten the nuts and bolts in a cross pattern
to the vehicle manufacturer’s specifications. Before starting the
engine, open and close the throttlebody to make sure there are
no obstructions.

8. Double check your work. Make sure there is no foreign ma­terial in the intake tract. Make sure all clamps, connectors, hos­es, nuts, and bolts are secure.

Reconnect the negative battery cable.

Instructions Revision

04.11.14

ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 [phone] www.ECONOAID.com