Aiphone NE-SSR, NE-SS-A User Manual

Vandal and Weather Resistant Sub Stations
- INSTRUCTIONS -
The NE-SS/A and NE-SSR are 2-gang vandal proof and weather resistant sub stations designed for use with the NEM, NDR and NDRM systems. They are constructed of 12 gauge stainless steel and are equipped with an option for an external output contact closure when the sub station places a call (relay required). The units either flush mount into a 2­gang box, or surface mount with the SBX-2G. Each unit includes tamper proof screws and a tool for installation. The NE-SSR features a red mushroom call button.
INSTALLATION:
1. For flush mounting, install sub station in standard 2-gang electrical box with min. 2-1/2" depth.
2. For surface mounting, install sub station in the SBX-2G surface mount enclosure.
3. IMPORTANT! These units are designed for use in normal weather conditions, and to allow drainage and evaporation of moisture that naturally gets into the unit. Do not apply caulking or silicone sealant around the unit when installing, and do not use weather stripping around the perimeter of the box when mounting. If sealing the unit is required, the bottom must remain unsealed. Sealing the unit will prevent or inhibit moisture from dissipating from inside the unit, which may cause corrosion or deterioration to the internal components over time.
MOUNTING:
NE-SS/A
NE-SSR
TORX
screws
2-GANG BOX
Do not apply sealant between unit and box.
NEM Master
1 2 3 ~
20
PS-2420UL
+
-
E +
-
H
duration of call-in
Dry closure
output for
NOTES:
NE-SSA/-SSR
Red
NE-SSA/-SSR
(w/dry closure output)
Red
1. The units flush mount into a 2-gang box.
2. To surface mount the NE-SS/A or NE-SSR, order the SBX-2G surface mount box separately.
NE-SSA/-SSR
(w/corridor lamp)
Red Blk Blu
Blk Blu
Wht
Blk Blk
RY-PA
Blk Blu
Yel
WIRE DESIGNATIONS:
Red: + side of speaker. Connect to station number on master station. Blue: Trigger for corridor lamp. 7V DC when call-in signal is activated. Black: - side of speaker, Common. Connect to E on master station. White: Negative trigger wire for extra relay contact closure at sub during call.
Blu Blu
NBY-4A
Page 1
Small wht & blk: Speaker connection to PCB Small brn (x2): Call button connection to PCB
WIRING DIAGRAM:
NE-SSA/NE-SSR
Red
Blk
Wht
NDRM Master
CP-544A board
1 E
H
2 E H
Dry closure
output for
duration of
call-in
Blk
RY-PA
Yel
NE-SSA/-SSR
(w/dry closure output)
Red
Blk
Blk
Wht
Blu
Blu
3 E
+
-
PS-2420UL
H
CP-544A board
A+
A-
B+
NOTES:
1. The units flush mount into a 2-gang box.
2. To surface mount the NE-SS/A or NE-SSR, order the SBX-2G surface mount box separately.
B-
H Q E S B
Y A1 V1 A2 V2
SPECIFICATIONS:
Power Source: Supplied by master station Speaker: 20 ohms, 2.5" diameter, water proof and puncture resistant, 2.4 oz. magnet Call Button: SPST call button, momentary activation
NE-SSR: Limited stop, red mushroom button.
Call Annunciation: Pressing the call button at sub activates and latches call at NEM master. The master
station's LED will be lit and a ringing tone will be heard until the call is answer ed. Communication: Hands free at sub. Master is push-to-talk or VOX with handset. Faceplate: 12 gauge stainless steel Mounting: Flush mount into a 2-gang box. Surface mount into SBX-2G, sold separately. Tamper proof screws
included (6x32 for use with flush gang box) with T-10 TORX bit.
Use hardware included with SBX-2G when installing sub into that unit. Terminations: Color-coded prewired pigtails Operating Temperature: Flush Switch rating: 14°F to 158°F; Mushroom Switch rating: -22°F to 185°F
Speaker rating: -67°F to 187°F Wiring: 2 conductors homerun; or 1 common plus 1 individual per sub, looped through each sub.
Shielded cable is recommended.
Use Aiphone #822202 or #821802 for homerun wiring, #822206 for up to 5 stations
on each run, or #822210 for up to 9 stations on each run. Wiring Distance: 420' with 22AWG; 1,000' with 18AWG Dimensions (HxWxD): NE-SSA/-SSR alone: 4-11/16" x 4-11/16" x 2"
With SBX-2G: 4-3/4" x 4-7/8" x 3-5/8" (Top) 2-3/8" (Bottom) Aiphone Communication Systems
1700 130th Ave. N.E. Bellevue, WA 98005 (425) 455-0510 FAX (425) 455-0071
Toll Free Technical Support:
1-800-692-0200
E-mail tech@aiphone.com
NE-SSA/SSR Instr.
1211JD
Loading...