Aiphone MY-CB User Manual

1192©

0 AlPHONE

VIDEO DOOR STATION I

Model;

INSTRUCTIONS

^ NAMES AND FUNCTIONS

(Surface-mount,

MY-CB

@ Locator LED @ CALL button ® Microphone

MY-CB is the video door station for use with MY-IBD or MY-IAD fixed camera system.

MY-CB

charcoal gray)

MY-1BD, MY-1AD

2 (NP)

Tor

NP: Non-polarized

Mounting accessories

SCREW (2) WOOD SCREW (2)

TEMPORARY

> WIRING

MY-CB

Non-polarized

HOLDING

MY-IBD MY-1AD

SPECIAL SCREWDRIVER SCREW

INSTALLATION LOCATION

The picture quality could be affected by outside light, as shown in drawings. Avoid the locations which are exposed to;

• Strong backlight (sunlight, street light, etc.) (darkens object image on monitor),

• Fluorescent light (creates flickering on monitor),

• Drastic temperature drops after rainfalls, etc. (fogging inside camera; can be restored soon)

Image viewing area;

All the figures are approximate.

' When shipped;

> When camera is

turned upward;

’ When camera is

turned downward;

^ INSTALLATION

If camera angle is not changed, proceed with installation, following steps O ? 0 > O ^nd ® only.

® Remove a screw cover, pulling from the bottom notch. Loosen

tamper-proof screw with the supplied screwdriver.

(2) Attach the back frame to SINGLE-GANG BOX or to wall

with the supplied screws or wood screws.

(3) Pull the tamper screw, and push CALL button, and remove the

front case from the MY-CB ¡main unit.

0 Connect wires on 2 terminals.

Attach the main unit to back frame.

0 Insert the supplied screw to temporarily hold the main unit to

back frame.

® Unscrew at 2 points to open the camera cover.

Take away the camera lens fixer(will not be reused).

@ Change the camera angle, pushing arrow part.

Be careful not to touch the lens surface. The camera gearing sound is heard, but this is not an unit disorder.

0 Reattach the camera cover.

Be careful that the weather-stripping rests in place.

@ Loosen the temporary holding screw.

Reattach the front case to the main unit, until it locks.

® Fasten the tamper screw and attach the cover.

MY-CB UNIT

? TAMPER SCREW (2)

SCREW SCREW

Pull strongly tamper screw.

WEATHER

STRIPPING LENS FIXER

CAMERA COVER

SCREW (2)

TEMPORARY

HOLDING SCREW

BACK FRAME siNGLE-GANG BOX

fl MY-C

83.5^

(3-5/16") SCREW

COVER

Push strongly CALL button.

BACK FRAME

SCREW (2)

for exposed (*) Indicates panned direction, cable run. when viewing on the monitor,

BACK FRAME .

Changing camera

lens angle;

UPWARD

DOWNWARD

SPECIFICATIONS

*Power source: *Camera unit: ^Scanning line: 525 lines. *Image viewing area: Vertically: approx. 51cm (1'.8")

*Camera angle adjustable: Upward: approx. 14.5°

*Minimum illumination: *Dimensions (H x W x D) & weight: *For further information, refer to the Instructions furnished with main room stations.

TO MAINTAIN PROPERLY

Clean MY-CB unit with a soft cloth dampened with neutral household cleanser. Never use lacquer thinner or benzine, etc. Be careful with the camera cover, as it could be scratched.

Do not splash water to MY-CB door station by hose, etc.

Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective

upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make

the final decision whether there is a defect in materials and/or workmanship; and whether or not the product is within the

warranty. This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation of instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover batteries or damage caused by batteries used in connection with the product. This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone. Aiphone will not be responsible for any costs incurred involving on site service calls.

Supplied by MY-IBD or main video monitor. CCD (Charge-Coupled Device) with infrared LEDs.

Horizontally: approx. 72cm (2'.5")

Downward: approx. 11.5° To each left or right: approx. 12°

1 lux or less (at 50cm/20" distance) 132 X 100 X 47.5 (mm) (5-1/4" x 4" x 1-3/4"). Approx. 300g (0.66 lbs.)

WARRANTY

Aiphone Co., Ltd., Nagoya, Japan Aiphone Corporation, Bellevue, WA, USA

MY-CB-I (E) 1192C

COMMUNICATION SYSTEMS

AIPHONE

HOME. BUSINESS, INDUSTRY.

Printed in Japan (E)