Aiphone MY-CA User Manual

0595©

PanTilt Video Door Station

INSTALLATION & OPERATION MANUAL

® AlPHONE

SYSTEM OUTLINE & FEATURES

The MY-CA is a compact, surface mount pan and tilt video door station. It can be used with any Aiphone MY video system (MY-1CD, MY-2CD, MY/IE, MY/TD-H, MY/LEF).

For 1 entry;

MY-1CD MY-CU

MYW-P1L

For 2 or max. 3 entries;

MY-2CD MYW-P3CB MYW-P3L

ill

--------------------------------

¡1

Connecting 1 At, 1A2 Terminals

I FEATURES

' Audio, video, and PanTilt control on 2 wires ' Pan and tilting of MY-CA camera

■ 100m, 330‘ to monitor on I.Ommo, 18AWG wire ’ Extended distance to 300 m, 980' with MYW-BA adaptor

(using 1.2mm0, 16AWG PE jacketed wire)

' Replace an existing doorbell and use the same wire

1A1, 1A2

NAMES AND FUNCTIONS

At, A2

1A1, 1A2

2A1,2A2

1A1, 1A2 2A1,2A2 3A1,3A2

------------

PanTilt MY-CA, when measured at 50 cm, 20" from the camera,

PACKAGE CONTENTS

> PanTilt video door station (MY-CA) > Tamper-proof screwdriver

^ m, J!.

1A1, 1A2 2A1,2A2 3A1,3A2

LAYOUT EXAMPLE

iif.

MY-CA IT^

Refer to the Installation & Operation manual packed with

main monitor or adaptor.

views an area of 51 cm, 20" vertically by 72 cm, 29" horizontally. On any and every inside monitor, operate Pan/tilt control pad to maximize viewing area, and Backlight button to view dimly lit or strongly backlit areas.

Packet of screws Installation & Operation Manual

I"!

li\

MY-1CD

INSTALLATION & WIRING-------------

I Wiring Use 2-conductor (parallel) cable. Coaxial cable

or 2 separate wires should not be used.

Parallel cable

YES

When existing chime wires are used, it is possible that the wires may contain AC voltage current. Locate and remove the bell transformer before actually connecting MY-CA.

Extra pair(s) in the installed cable can affect image quality, and must be terminated with a 120 ohm resistor at each end of wires at both MY-CA location and inside monitor(s).

Installation

Do not mount the MY-CA with a horizontal surface directly below it (like a counter top), as feedback may occur

- 1 -

(microphone is looated on the bottom of unit.)

(Extra wires)

1 aii^a_

MY-CA employs a CCD camera, and its perfor mance can be affected by bright direct light, such as strong sunlight, gate light or street or porch light which is directed into the camera lens. Use backlight button to compensate for silhouetted images.

c§

1 M Y - 1 C D ,

etc.

MOUNTING

Back frame

★ Do not apply any sealant around MY-CA, as openings are

provided for ventilation.

Single-gang box

83.5 mm (3-5/16”)

Plug off power supply prior to wiring on any unit.

MY-CA surface-mounts on wall with 83.5mm, 3-5/16” guide, or on single-gang box.

1. Remove screw cover, pulling from bottom notch,

2. Loosen a tamper-proof screw with supplied driver.

3. Mount back frame at 2 points.

4. Secureiy connect non-polarized A1, A2 terminals with 2 wires with sufficient insulation.

5. Remount MY-CA on back frame.

5 WIRING i OPERATIONS

Wiring distance: WIY-CAto Video-monitor MY-1CD ,etc.

TECHNICAL PRECAUTIONS

MY-CA has a camera angle presetting feature, programmable on inside video monitor. Refer to each Manual of MY-1CD, MY-2CD, etc. Installation location: The MY-CA is weather resistant, but for best results it should be protected from direct weather conditions. An eave or overhead cover is

Temperature: The MY-CA is rated to operate at temperatures between -10°C ~ 60°C (14° and 140°F), When the outside temperature lowers rapidly, the

Cleaning: Clean the unit with a soft cloth and neutral household cleanser. Do not use an abrasive cleaner or cloth.

SPECIFICATIONS

recommended to protect it from direct rainfall.

camera lens may fog up slightly, causing a blurry picture at the inside monitor. The ventilation openings will allow the moisture to evaporate, and tho picture will return to normal.

I Pan/tilt viewing area shown by dotted line

23cm (1T‘) upward

The red LED is lit to locate call button, day or night. A single push of Call button activates inside video monitor, as well as a 4 or 2-tone chime (or other). When inside station replies, talk handsfree.

★ Poor lighting conditions:

The MY-CA infrared illumination will light the image of the caller when positioned within 50cm, 20" in front of the camera, and will see in near darkness (1 Lux of

light).

Power source Camera unit Scanning lines image viewing area

Minimum illumination Dimensions & weight

This equipment has been tested and found to comply with the limits for a Class В digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful inteference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• increase the separation between the equipment and receiver. • Consult the dealer or an experienced radioЯV technician for help.

Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of 2 years after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the final decision whether there is a detect in materials and/or workmanship; and whether or not the product is within the warranty. This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation of instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover batteries or damage caused by batteries used in connection with the product. This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone. Aiphone will not be responsible for any costs incurred involving on site service calls.

Aiphone Co., Ltd. Nagoya, Japan

Aiphone Corporation, Bellevue, WA, USA

MY-CA-I(E) 0595F

Camera is powered from monitor unit CCD camera 525 lines at 50 cm, 20" from camera Vertical 90cm, 3'. Horizontal 180cm, 6' (140cm, 47" in still position) when panned and tilted fully 1 Lux at 50cm, 20" from camera MY-CA 132mm high x 100mm wide x 47.5mm deep. 5-1/4” H X 4” W X 2” D. Approx. 350g (0.77 ibs.)

WARRANTY

-2-

COMMUNICATION SYSTEMS

AIPHONE

HOME, BUSINESS, INDUSTRY.

Printed in Japan (E)

•i*

-i-