Aiphone LE-SSV User Manual

1011

Vandal Resistant Sub Station with built in Color Pinhole Camera for use with

AP-M, LAF-C, LDF-C, LEF, LEM, MP-S Systems

- INSTRUCTIONS -

The LE-SSV is a 2-gang stainless steel vandal proof and weather resistant sub station designed for use with the systems listed above. It is constructed of 12 gauge stainless steel and has a stand alone color camera built in. The unit either flush mounts into a 2-gang box, or surface mounts using the SBX-2G. Each unit includes a 12V DC power transformer for the camera, tamper proof screws, and a tool for installation.

INSTALLATION:

1. For flush mounting, install sub station in standard 2-gang electrical box with minimum 2-1/2" depth.

2. For surface mounting, use the SBX-2G surface mount enclosure (sold separately).

3. Only the 12V DC power supply included should be used to power the LE-SSV camera.

4. IMPORTANT! These units are designed for use in normal weather conditions, and to allow drainage and evaporation of moisture that naturally gets into the unit. Do not apply caulking or silicone sealant around the

unit when installing, and do not use weather stripping around the perimeter of the box when mounting. If

sealing the unit is required, the bottom must remain unsealed. Sealing the unit will prevent or inhibit moisture from dissipating from inside the unit, which may cause corrosion or deterioration of the internal components over time.

50cm

20”

Speaker

Front View Back View

Camera

Call button

45cm

18”

50cm / 20”

67cm 26½”

The view achieved if the subject is 20" from the camera is: 18" Vertically and 26½” Horizontally

Transparent corner shadowing on the picture is normal.

Page 1

WIRING DIAGRAMS:

LEM SYSTEM:

LEM Master LE-SSV

Power

Source*

LEF SYSTEM:

PS-1225UL

LEF, LAF/LDF

Master Station*

12V DC power input for camera

(Red - Must use supplied transformer)

Video output to monitor

or CCTV system (Yellow)

MP-S SYSTEM:

*LEM-1 or LEM-3: Use SKK-620 (6V DC)

LEM-1DL: Use PT-1210N (or any source providing 12-16V AC or 12-24V DC)

12V DC power input for camera

(Red - Must use supplied transformer)

Video output to monitor

or CCTV system (Yellow)

LE-SSV

Red

2 ~

Blk*

12V DC power input for camera

(Red - Must use supplied transformer)

Video output to monitor

or CCTV system (Yellow)

Blu

Red

Blk Blu

LE-SSV

Red

Blk*

Blu

Jumper Blue & Black wires together

* In a single master LEF system only, 2 conductors homerun can be used with the BLK and BLU wires tied together and "E" and "-" jumpered at the master.

MP-S Master

PS-1225UL

AP-M SYSTEM:

LE-SSV

Red

Blk Blu

1 (2) (3)

12V DC power input for camera

(Red - must use supplied transformer)

Video output to monitor

or CCTV system (Yellow)

AP-M Master

1 E 2 E ~

12V DC power input for camera

(Red - must use supplied transformer)

Video output to monitor

or CCTV system (Yellow)

LE-SSV

Red

Blk Blu

Jumper Blue & Black wires together

LE-SSV

Red

Blk Blu

12V DC power input for camera

(Red - must use supplied transformer)

Video output to monitor

or CCTV system (Yellow)

Page 2

+ 1 hidden pages