Aiphone BA-1P INSTALLATION INSTRUCTIONS

Special

FAX [phone]

E-MAIL:

[e-mail]

0598bkjd

Order
Products

BA-1P

Paging Adaptor

Use with:

AP-M or MP-S Series Systems

- INSTRUCTIONS -

The BA-1P Paging Adaptor allows paging to external speakers from the AP-M or MP-S series
master stations. For each zone of paging, use a BA-1P with the appropriate sized amplifier.
The BA-1P provides outgoing paging only. Talkback is not available.

WIRING DIAGRAM:

AP-5M

1
2
3
4
5

E

BA-1P

OUTPUT

Yel
Grn

NOTES:

1. The above example shows station 5 accessing the paging
zone. Any unused station can be used for a paging zone.

2. The colored wires at each end of the BA-1P are the Input
and Output. Connect them to the intercom and amplifier as
shown.

3. Only wiring concerning the BA-1P is shown here. For
complete installation information see the system's
instruction manual.

4. The TONE control is located on the top of the BA-1P, and
requires a screwdriver for adjustment.

Org
Brn

TONE

INPUT

TONE: Control to adjust the

paging volume

Amplifier

HOT
GND

OUTPUT

TO PAGING

SPEAKERS

SPECIFICATIONS:

Power Source: Supplied by master
Input: 8 ohms
Output: 10K ohms
Amplifier input
requirements: Aux input (10K ohms)
Dimensions: 4-1/8"H x 2-1/2"W x 1-1/2"D

Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
[phone]

TOLL FREE TECHNICAL SUPPORT:

[phone]

TOLL FREE FAX LINE:

[phone]

BA-1P COLOR CODE DEFINITIONS:

Org: Hot side of output

(Connect to amplifier input)

Brn: Ground side of output

(Connect to amplifier input)

Yel: Hot side of BA-1 input

(Connect to station # on master)

Grn: Ground side of input

(Connect to "E" terminal on master)

BA-1P Instr.