- 81 -
MAINTENANCE 6
6
Tables of scheduled maintenance
km (mi) covered
Service coupon
ABCDEFG
Every time vehicle is used
Every time vehicle is used
Every time geometry is changed
0 1000 6000 12000 18000 24000 30000 36000
(600) (3800) (7500) (11200) (14900) (18600) (22400)
Pre-
delivery
Description Operation
Fork seal rings Check for leakages ●●●●●●
Screws and nuts Check tightening ●●●●●●●●
Manifold and cylinder
Check
head bolts ●●●●●●●●
Hose clamps Check ●●●●●●●
Electrical equipment Check operation ●●●●●●●●
Battery Check connections ●●●●●●●●
Instrument panel Check ●●●●●●●●
Lights/Visual signals Check
Headlight Check/Adjust ●
Horn Check
Ignition switch Check ●●●●●●●●
Choke Check ●●●●●●●●
Exhaust system Check noise level ●●●
- 82 -
MAINTENANCE 6
6
Tables of scheduled maintenance
km (mi) covered
Service coupon
ABCDEFG
0 1000 6000 12000 18000 24000 30000 36000
(600) (3800) (7500) (11200) (14900) (18600) (22400)
Pre-
delivery
Description Operation
Silencer brackets Check tightening ●●●●●●●
General cleaning ●●●●●●●
General lubrication ●●●●●●●
General test ● ●●●●●●●
- 83 -
MAINTENANCE 6
6
6.2 Tools and accessories supplied
A bag in the glove compartment contains the following
tools:
- 1 hexagonal bar (10 mm hexagon);
- 6 Allen keys (2.5 - 3 - 4 - 5 - 6 - 8 mm hexagons);
- 1 spanner for rear wheel eccentric with extension;
- 2 fuses (7.5 A and 15 A).
The following accessories are also supplied:
- 1 rear stand;
- 1 ignition spanner (16 mm hexagon);
★ 1 motorcycle canvas cover;
★ 2 handgrip covers;
- 1 document holder.
Description Specifications Recommended product
Engine lubrication oil API SJ SAE 10W/60 AGIP RACING 4T 10W/60
Coolant Ethylene glycol diluted
with 40 percent AGIP ECO - PERMANENT
distilled water
Brake and clutch fluid DOT4 AGIP BRAKE FLUID DOT4
Drive chain lubrication oil AGIP CHAIN AND DRIVE SPRAY
6.3 Table of lubricants and fluids
- 84 -
MAINTENANCE 6
6
6.4 Removing/fitting the right-hand side fairing
Pull off the quick fastenings and then remove the side
fairing.
- 85 -
MAINTENANCE 6
6
Fit the side fairing, taking care to position the front
profile as shown in figure A.
Fasten the panel by positioning the tab in the
lower part of the fairing as shown in figure B.
AB
Radiator
Side fairing front
profile
- 86 -
MAINTENANCE 6
6
6.5 Checking the engine oil level
Check the oil level while the engine is off and cold. In
any case, the engine must have been off for at least ten
minutes.
The check must be performed after placing the motorcycle in an upright position on a horizontal surface.
The level must be between the MAX and MIN marks on
the crankcase.
If the oil level is below the MIN mark, top up as
described in § 6.5.1. Never exceed the MAX level.
Danger - W arning:Do not start the engine if the
oil level is below the MIN mark.