Agusta MV F4 750 Engine Service
Specifications and Main Features
- Besides the Minimum load voltage also consider the Corr wave: bar1 - 7.5, bar max: 13.5 mm per at 280.
- Required to have th minimum of 12 Volt required with no load.
- Let the throttle angle be within 1.5 and 1.7.
- The CO value needed is roughly 45% with tolerance of 0.5% at the rate of around 1100 and 50 rpm.
- Combined dt external seal o/d: Exhaust: 24.6 and Inlet is 28.6 mm is required.
- Combined valve guide clearance: exhaust is 0.02 + 0.04 and intake is 0.01 + 0.03 mm.
- The combined minimum thickness in P-C clearance is 0.025 and p-cm is 0.045 mm.
- The maximum bm working clearance is 0.012 and minimum is 0.038.
- Clutch plate minimum required thickness is 3 mm.
- The maximum axial clearance when idle gears are engaged is 0.10 mm.
Frequently Asked Questions
- Q: What is the minimum bar required with load?
A: Acceptable minimum for load is 7.5 and maximum goes upto 13.5.
- Q: If the minimum bar exceeds the maximum bar what to do?
A: If the maximum bar is compressed without the bar then one should consider with thinner head gaskets or valve stem seals/ piston rings.
- Q: What angle adjustment in terms of Throttle is to be made?
A: It should exceed neither 1.5 and 1.7 degrees angle.
- Q: How do I check the CO value?
A: To check the CO value, the value needs to be measured around 1100 ± 50 revolutions per minute which is equal to 45% ± 0.5%.
- Q: What is the wear limit for piston-cylinder clearance?
A: If a piston and cylinder have a clearance that is higher than 0.1 mm then the clearance is labeled as “too high”
- Q: When should I replace the valve springs?
A: A measurement lower than thirty mm for the free length of spring indicates the need to replace the valve springs.
- Q: What clearance limits should be maintained for valve guides?
A: The limit for the intake valves is 0.1 mm and the limit for the exhaust valves is 0.12 mm
- Q: What is the minimum axial clearance for idle gears?
A: Idle gears have a minimum measurement of 0.10 mm for the axial clearance.
User Manual
Loading...