Ag Spray AG15DLXRG User Manual

Owner's Manual



(15 Gallon Deluxe Lawn & Garden Spot Sprayer w/Coiled Hose)

•

•

•

•

•

Your sprayer has been mostly assembled at the factory. The
only requirement will be for you to hook up your battery
leads to a fully charged 12 Volt battery. The red wire must
be connected to the "hot" lead, and the black wire should be
connected to the ground.

Technical Specifications

15 Gal. Corrosion-Resistant Polyethylene Tank
12 Volt Diaphragm Pump, 1.4 g.p.m. - 45 p.s.i.
TriggerJet Handgun
15 Ft. Coiled Handgun Hose
Bypass/Pressure Relief Valve (for pressure control)

Assembly

General Information

Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your lawn
& garden spot sprayer. Please read it carefully, as it furnishes
information which will help you achieve years of trouble-free
operation.

Warranty/Parts/Service

Products are warranted for one year from date of purchase
against manufacturer or workmanship defects.

Commercial users have a 90 day warranty.

Your authorized dealer is the best source of replacement parts
and service. To obtain prompt, efficient service, always
remember to give the following information...

Operation

Your sprayer may be equipped with (2) ON/OFF switches.
One may be on the wire assembly that you hook up to your
battery, the other is on the pump itself, on the opposite end
of the pressure switch. The "-" is the "ON" position and the
"o" is the "OFF" position for the switches. Make sure both
switches are depressed in the "-" position for operation.

Always fill the tank with a desired amount of water first, and
then add the chemical slowly, mixing as you pour the
chemical into the tank. You may use the handgun to spray
into the solution in order to mix the chemical and water.

Initially begin spraying by opening the handgun. This will
enable the air in the line to be purged through the handgun
tip, while building pressure.

The pumping system draws solution from the tank, through
the strainer/filter, and to the pump. The pump forces the
solution under pressure to the handgun and/or boom
nozzles.

Open the handgun by squeezing the handle lever.

•

Rotating the adjustable nozzle tip on the handgun will

•
change the tip pattern from a straight stream to a cone
pattern (finer mist).

- Correct Part Description and/or part number.

- Model number/Serial number of your sprayer.

Part descriptions and part numbers can be obtained from the
illustrated parts list section(s) of this manual.

Whenever you need parts or repair service, contact your
distributor/dealer first. For warranty work, always take your
original sales slip, or other evidence of purchase date, to your
distributor/dealer.

www.agspray.com

1100 New Industry Lane

Hopkinsville, KY 42240

P: 800-637-7172
F: 270-885-7392

Form No. 1991 [5008287 (02/10)] Printed in the U.S.A.

104 Eastman Street

Greenwood, MS 38930

P: 800-844-4524
F: 662-455-4442

1563 S. Oates Street

Dothan, AL 36301

P: 800-227-4098
F: 334-673-1974

After Spraying

Troubleshooting the Pump:

After use, fill the sprayer tank part way with water. Start
the sprayer, and allow the clear water to be pumped
through the plumbing system and out through the spray
nozzles.
Refill the tank about half full with plain water and use
FIMCO Tank Neutralizer and Cleaner, and repeat
cleaning instructions above.
Flush the entire sprayer with the neutralizing/cleaning
agent, then flush out one more time with plain water.
Follow the chemical manufacturer's disposal instructions
of all wash or rinsing water.
For the boom, (if applicable) remove the tips and
screens from the nozzle assemblies. Wash these items
out thoroughly. Blow the orifice clean and dry. If the
orifice remains clogged, clean it with a fine bristle (NOT
WIRE) brush, or with a toothpick. Do not damage the
orifice. Water rinse and dry the tips before storing.

WARNING: Some chemicals will damage the pump
valves if allowed to soak untreated for a length of
time! ALWAYS flush the pump as instructed after
each use.

Winter Storage

Drain all water out of your sprayer, paying special
attention to the pump, handgun, and valve(s). These
items are especially prone to damage from chemicals and
freezing weather.

Pump will NOT run:

- Check inline fuse on the wires on the pump. (if
applicable)

- Make sure on/off switch is in the 'on' position (-).

- Make sure you 12 volt source (battery) is fully
charged.

- Insure a tight connection at the battery clips.

Pump runs, but does not prime:

- Check line strainer (screen) in the tank, connected
to the bottom of the intake tube. Periodically take the
screen at this location out and clean it.

- Make sure the bypass line valve is closed, to allow
the pressure to build up in your system. (If equipped
with bypass)

- Unscrew the head portion of your pump and remove
the check valve assembly from inside. You need to
make sure the O-Ring comes out with this piece as
well. (See the exploded view to help identify these
components) These pieces can be cleaned which, in
most cases, will help restore some, if not most, of
your prime. Soak this check valve in a solution of hot,
soapy water. A good name-brand dishsoap works
well for this. A little bit of 'scrubbing' with perhaps an
old toothbrush may be required to actually break up
any build-up that may be on the check valve. Rinse
off the pieces and replace them back into your pump.
Reassemble the pump. Hook it back up and test.

The sprayer should be winterized before storage by
pumping a solution of RV antifreeze through the entire
plumbing system. This antifreeze solution should remain
in the plumbing system during the winter months. When
spring time comes and you are preparing your sprayer for
the spray season, rinse the entire plumbing system out,
clearing the lines of the antifreeze solution. Proper care
and maintenance will prolong the life of your sprayer.

12 Volt Pump

SHURflo Model No: 8000-543-250

4

2

3

6

5

1

(8000-543-250) BY-PASS PUMP:

1.4 gpm, Viton Valves, Santoprene Diaphragm, 1/4" FPT

Adaptor mounted on switch port, 3/8" FPT ports no switch.

Item

No

1
2
3

4
5
6

Part

Number

5075019
5084089
5168759

516876011
5168761
5168762

Description

Qty

1

Pkg. (4) Grommets
Upper Housing

1
1

Check Valve Kit
Valve Assembly Kit

Diaphragm

1

Drive Assembly

List

Price

2.99

17.85

10.25

39.11

17.60

30.10

Page 2