
I. Thank you for purchasing the S05 Waterproof Digital Audio
Player produced by AGPTek. Before using the player, please
read the manual carefully. If you have any question or any idea
about this product, please email support@agptek.com. We are
look forward to hearing from you!
II. We strongly suggest you to back up the data before transferring
to the player in case there is an accident happened to the
Digital Audio Player. We are afraid that we could not bear
responsibilities for data loss due to mistaken operation or
III. Users are neither allowed to repair the machine nor to the
open the rear cover of the machine by themselves, or else we
won’t be able to provide you with regular after-sale service.
IV. Manufacturers of Flash machine usually calculate the capacity
by the scale 1000, i.e. 1K=1000byte, 1M=1000K and 1G=1000M.
The operation system equalizes 1024K to 1M and the formatted
report capacity will be less than the nominal capacity. System
files would occupy a bit of space under different systems.

Charge/Sync: plug in USB cable; Listen:
plug in headphones.
Wear on your arm or goggles, ready
for sports.
Next Track: One press;
Volume+: Long press and hold.
4. Previous Track/Volume-
Previous Track: One press;
Volume-: Long press and hold.
This device plays in sequence mode by
default, press the previous Track and
Play buttons simultaneously
to turn Shuffle mode on and off.
-Play/Pause: press once to toggle
-On: hold the play button until light
turns on, then music will play
automatically
-Off: hold on the play button until the
red light flashing is off.
-Reset: hold on for 10 seconds.
Shows the LED light status

LED status in different situations:
Red light slowly flashing 5 times
and automatically turn off.
When the player is under music
repeat mode, the blue light
slowly flashing.
When the player is under
shuffle mode, the LED stays
blue.
The LED stays red and
automatically turn off after 5
minute.
The LED stays blue and Red
light flashing quickly.
The LED flashing blue and red
simultaneously when the player
is under charging.
The LED stays blue and red
simultaneously when the player
is charged.
Connect it to the computer with the enclosed Micro USB lead, the
mp3 player will show up as a removable disk as soon as the
computer recognize it and then just drag files onto the mp3 player.
If your computer cannot recognize the player, the enclosed Micro
USB lead may has problem please use another Micro USB lead to

1. Plug the headphone end of the USB cable into the player’s
2. Charge it via the enclosed Micro USB lead through PC or the
3. Charge for about 1.5 hour, or until the flashing Red light and
blue light changes from flashing to stay bright.
1. Make sure battery is charged.
2. Connect to computer and check for response. (LED flashes RED if
computer recognizes player).
-No sound comes from headphones
1. Turn up volume (hold down Next Track button).
2. Gently clean out headphone jack.
3. Make sure the audio file format is supported.
4. Check if files play correctly on computer.
1. Make sure the player is correctly connected to the computer
(LED should be flashing RED).
2. Make sure there is enough memory available to store the files
-Light is on, but buttons do not respond
1. Turn off player (press and hold the Play/Pause button for 3
2. Press and hold the Play/Pause button for 10 seconds to reset the
controls (LED will flash RED and BLUE at the same time and then
1. Don’t soak it continually in the water more than 1 hour per time.
2. To avoid corrosion and rust, please simply wash it in clean water
3. Please ensure the player is totally dry to connect PC or charging.
4. Using the cap to avoid dropping the waterproof earphone when