Ferrites
Ferrites are included in the Agilent Technologies 1670G-series logic analyzer
shipping carton for each logic analyzer cable (two pods). When properly installed, the
ferrites reduce RFI emissions from the logic analyzer module.
In order to ensure compliance of the Agilent 1670G-series logic analyzer to the CISPR
11 Class A radio frequency interference (RFI) limits, you must install the ferrite to
absorb radio frequency energy.
Note: Adding or removing the ferrite will not affect the normal operation of the
analyzer.
Ferrite installation instructions
Use the following steps to install the ferrites on the logic analyzer cables.
Place the ferrite halves on the logic analyzer cable like a clamshell around the whole
1
cable. The ferrite should be no more than 15 cm (about 6 in) from the rear panel of
the logic analyzer.
2 Insert the clamps onto the ends of the ferrites. The locking tab should fit cleanly in
the ferrite grooves.
Ferrite installation instructions
When properly installed, the ferrite should appear on the logic analyzer cable as shown.
01670-92002
01670-92002
01670-92002
Loading...