Aga Ranges 30AIM User Manual
Aga 30AIM 115V
Installation
Operation &
Maintenance
Instructions
For models with serial number below 20070608001
Aga ACIM-15
Remove Packaging
Your ice machine has been packed for shipment with all
parts that could be damaged by movement securely
fastened. Before installing the ice machine, be sure all
packing materials and tape have been removed.
Important
Save the carton packaging until your ice machine has been
thoroughly inspected and found to be in good condition. If
there is damage, the packaging will be needed as proof of
damage sustained in transit.
Starting Out
All specifications and product design subject to change without notice.
Such revisions do not entitle the buyer to corresponding changes, improvements,
additions, replacements or compensation for previously purchased products.
2
Installation
Select Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Cabinet Clearance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Electrical Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Grounding Method . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Drain Plumbing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Water Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Caring for Your Ice Machine
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Care of the Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Help Prevent Tragedies . . . . . . . . . . . . . . . . . . . . . . . . . .6
Cleaning Your Ice Machine . . . . . . . . . . . . . . . . . . . . . .7
Things to Remember . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Obtaining Service
Before Calling for Service . . . . . . . . . . . . . . . . . . . . . . . .9
How to Obtain Service . . . . . . . . . . . . . . . . . . . . . . . . . .9
For Your Records . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Troubleshooting
Troubleshooting One . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Troubleshooting Two . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Troubleshooting Three . . . . . . . . . . . . . . . . . . . . . . . . .12
Troubleshooting Four . . . . . . . . . . . . . . . . . . . . . . . . . .13
Warranty Information
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14
Installation
All specifications and product design subject to change without notice.
Such revisions do not entitle the buyer to corresponding changes, improvements,
additions, replacements or compensation for previously purchased products.
3
Cabinet Clearance
Ventilation is required for the bottom front section of the
unit where the grille is located. Keep this area open and
clear of any obstructions.
Adjacent cabinets and countertop can be built around the
unit as long as no top trim or countertop is installed lower
than the top of the hinge. Make certain that the glides
supplied with the ice machine are installed according to
instructions. Make certain your ice machine is level.
Leveling adjustments can be made by raising or lowering
the glides on the bottom of the unit.
Electrical Connection
Check the serial nameplate for the correct power supply.
Use only the electrical power supply specified on the serial
nameplate. Do not use an extension cord.
Grounding Method
This ice machine is equipped with a power supply cord
with ground. It must be plugged into a mating grounding
type receptacle in accordance with the National Electrical
Code and applicable local codes and ordinances.
THIS UNIT SHOULD NOT, UNDER ANY CIRCUM-
STANCES, BE UNGROUNDED.
DISCONNECT POWER SOURCE BEFORE
ADJUSTING LEVELING LEGS
Select Location
The proper location will ensure peak performance of your ice
machine. Choose a location away from heat and out of
direct sunlight. Best performance will be maintained when
installed within the following parameters:
Ideal Ambient Temperature Range*
built-in
freestanding
* Ice Machine will not perform correctly in ambient temperatures less than 55°F.
55-80°F
55-90°F
Installation: Drain Plumbing
All specifications and product design subject to change without notice.
Such revisions do not entitle the buyer to corresponding changes, improvements,
additions, replacements or compensation for previously purchased products.
4
Drain Plumbing
Your ice machine uses a gravity drain, (figure 1) that
requires 5/8" I.D. tubing from the back of the ice machine
to a plumbed connection to a sanitary sewer. Remove the
access panel to plumb in drain connection. Gravity drain
location for built-in units can be within the area shown in
figure 3. An optional drain pump, (figure 2) can be
purchased for your ice machine if a gravity drain is not
accessible.
OBSERVE AND FOLLOW ALL LOCAL CODES WHEN
INSTALLING ICE MACHINE.
Gravity Drain Location
* With optional filler kit
FAILURE TO USE ADEQUATE DRAINAGE SYSTEM
WILL RESULT IN SURROUNDING WATER DAMAGE
AND/OR POOR ICE PRODUCTION.
figure 1
figure 2
figure 3
Water Supply
All specifications and product design subject to change without notice.
Such revisions do not entitle the buyer to corresponding changes, improvements,
additions, replacements or compensation for previously purchased products.
5
Water Supply
This ice machine must be connected to a potable, active
cold water supply line delivering water pressure at a
minimum of 20 psi and maximum of 120 psi.
• Water connection is made through a right angle garden
hose fitting. See garden hose fitting for detailed instruction sheet.
• A water filter is recommended for this unit. A quality filter
can remove particles as well as remove taste and odors
from water. Do not use any thread sealers.
• Softened water is not recommended. This will produce
mushy, cloudy ice cubes that will stick together.
• De-ionized water is not recommended. This water will not
form solid ice cubes.
• A water specialist can recommend proper water treatment.
• After installation of water line, turn on water and check for
any leaks. Additional tightening may be needed.
• Allow for extra water line for built-in installations for easy
removal of unit and to help prevent the water line from
kinking.
Loading...