AFX RF8920N M Users Manual

Product parameters:

Category Item Parameter

Frequency range 2.442GHz

Wireless

parameters

Hardware

parameters

Transmitting

power

Receiving

sensitivity

Antenna type Onboard antenna

Data interface SPI

Operating Volt 3.3V

Supplying current ≥50mA

Power

consumption

(Typical)

Operating

Temperature

Size 13.8x24.8x2.0mm

2dBm

-96dBm@62.5Kbps

Modem Sleep: ~20mA

Light Sleep: ~2mA

Deep Sleep: ~0.02mA

-40℃ ~ +85℃

Package size:

TOP: Bottom:

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the

equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-

located or operating in conjunction with any other antenna or transmitter.

If the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which

the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the

following: “Contains Transmitter Module FCC ID: 2AR7I-RF8920N-M Or Contains FCC ID: 2AR7I-RF8920N-M”

when the module is installed inside another device, the user manual of this device must contain below warning statements;

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the

equipment.

The devices must be installed and used in strict accordance with the manufacturer's instructions as described in the user documentation that

comes with the product

Any company of the host device which install this modular with limit modular approval should perform the test of radiated emissionand
spurious emission according to FCC part 15C : 15.247 and 15.209 requirement,Only if the test result comply with FCC part 15C : 15.247 and

15.209 requirement，then the host can be sold legally.