AFX REF131200L30D1RB User Manual

REF Series Surface Mounted LED Fixture

Fig. 1

Models REF13 / REF16

Safety Precautions

Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.

It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.

Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.

Assembly Instructions

1. Preparing for installation

A. Disconnect electrical power before installing or servicing any part of

this fixture

B. Remove fixture from carton; remove frame (6), diffuser lens (3) and

hardware bag

C. Install stem (2) firmly into coupler located in center of ceiling pan (1).

Install two nuts and lock washer to secure stem as shown (Fig.1)

2. Wiring

All wiring must take place inside junction box. Caution: Make

sure power is off at fuse or circuit breaker box. Check power wires for
damage or scrapes. If power supply wires are within three inches of LED
driver, use wire suitable for at least 90C (194F). Note: Most dwellings
built before 1985 have supply wire rated to 60C. Consult a qualified
electrician before installing.

Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).

To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.

This fixture is intended to be used for general indoor lighting in dry
or damp locations only.

A. This unit will not operate properly unless connected to a “grounded”

electrical circuit. Electrical shock, over heating, low or no light output,
and shortened lamp life can result if proper grounding is not done.
Securely attach green (or green and yellow) wire to ground supply
wire

B. Using wire nuts (provided), connect white (common) supply wire to white fixture lead.

Connect black (hot) supply wire to black fixture lead. Do not mix wires. Pull on each wire
lead to make sure connections are secure. Make certain no bare wires are exposed outside of
wire connectors. Note: fixtures with universal voltage power supplies are pre-wired with a
disconnect. Refer to the included guide for using the disconnect

3. Mounting fixture

A. Attach ceiling pan to junction box (not provided) through keyhole slots with two #8 –32 x 1”

screws (provided)

4. Mounting diffuser

A. Slide the diffuser over the stem in the ceiling pan. Secure diffuser with rubber washer (4) and

nut (5). Install frame (6) by threading it onto stem

5. Power to the fixture can now be restored

Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 5
years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover
failure due to improper installation, misuse, mishandling or damage incurred in transit.

Page 1 of 1 8060820 R0