AFX OCFW70050LBK User Manual

Outdoor Ceiling Fixture

Model: 326928

& OCFW70050LBK

warrants this fixture is free from defects in materials and workmanship when installed and used under

years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or

not cover failure due to improper installation, misuse, mishandl

Safety Precautions

Read all safety precautions and installation instructions carefully before

installing or servicing this fixture. Failure to comply with these

instructions could result in potentially fatal electric shock and/or

commended that a qualified

fixture must be wired in accordance with all national and local

Do not handle any energized fixture or attempt to energize any fixture

with wet hands or while standing on a

ASSEMBLY INSTRUCTIONS

Preparing for installation

at fuse or circuit breaker box before installing or servicing any part of this fixture.

Carefully remove the fixture from the carton, and check that all parts a

of the screws or parts which are needed for installing the fixture.

with

Place diffuser (2) on the frame bottom;

frame sides.

all wiring must take place inside junction box.

Make sure power is off at fuse or circuit breaker box. Check power wires for damage

are within three inches of

Note:

to 60C. Consult a qualified electrician before installing.

junction bo

to appropriate wire. Secure

from the fixture and power source to the green screw on the gem bar

the fixture is connected to the black wire from power source.

The white wire from the fixture is connected to the white (neutral) wire from power source.

Tuck all connections neatly into junction box.

). Adj

Secure the necessary length with nut (7).

B. Install two longer screws (13) (supplied) on the backpanel and secure

over stem (

135. Restore power at fuse or circuit breaker box.

ing or damage incurred in transit

re included, as shown in figure below. Be careful not to misplace any

power supply

Most dwellings built before 1985 have supply wire rated

(suppli

(supplied

in the gem bar so that approx. 3/8”

those

with two acorn nuts (1

LED Flushmount

normal operating conditions for a

-

To reduce the risk of electrical shock, and to assure proper operation,

this fixture must be adequately grounded. To

grounding, there must be a separate ground wire (green)

this fixture and the ground connection of your main power

This fixture is intended to be used for general

120VAC / 60Hz

This fixture is designed for use in a 110
Do not use on a dimming circuit.

120VAC, 60Hz fused circuit.

property damage.
It is re

electrical codes.

1.

A. Disconnect electrical power
B.

A. Assemble 5 glass panels
B.
C. Place four diffusers (3) on

secure the glass panels.

2. Wiring-

Caution:

or scrapes. If power supply wires
suitable for at least 90C (194F).

D. Secure gem bar (4) on the
F. Make all wire connections
G. Connect the green wires
(4).
H. The black wire from
I.
G.

3. Mounting

A. Thread nut (7) on stem (6
is exposed.

(9) (supplied).
B. Install back panel (8)

4. Place the frame (11) over two (

electrician perform all wiring. This

wet or damp surface or in water.

metal frame (1):

Fold four metal tabs to

the ballast

x (not supplied) with two screws (5)

with wire nuts

ust the length of the stem

6) and secure it with the thumbnut (10).

) backpan screws and secure it

between
supply panel.

damp locations only.

, use wire

ed)

).

with the two nuts

2).

accomplish proper

contact

outdoor lighting in dry or

Limited Factory Warranty
AFX Lighting, Inc.
period of 3

1 of 1

components; it does

8060664 R4