AFX MTRF4200LEDRB3K User Manual

LED Fixed Rail Luminaire

Surface Mount

Model: MTRF4200LED 120VAC / 60Hz

Safety Precautions

Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with these
instructions could result in potentially fatal electric shock and/or
property damage.

It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.

Do not handle any energized fixture or attempt to energize any fixture
with wet hands or while standing on a wet or damp surface or in water.

This fixture is designed for use in a 110-120VAC, 60Hz fused circuit
and can be used in conjunction with most 2-wire, triac dimmers.

To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) contact
between this fixture and the ground connection of your main power
supply panel.

This fixture is intended to be used for general indoor lighting in dry or
damp locations only.

ASSEMBLY INSTRUCTIONS

Step1. Preparing for installation-Fig.1

A. Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture.
B. Carefully remove the fixture from the carton.

Step 2. Remove circular gem bar (1) from the fixture base by removing two screws.
Wiring-all wiring must take place inside junction box (not included)

Caution: Make sure power is off at fuse or circuit breaker box. Check power wires for damage or scrapes. If power

supply wires are within three inches of the ballast power supply, use wire suitable for at least 90C (194F).
Note: Most dwellings built before 1985 have supply wire rated to 60C. Consult a qualified electrician before
installing.
Step 3. Install circular gem bar (1) (supplied) on the junction box (not supplied) by securing it with two screws (2)
(supplied).

Step 4.

A. Make all wire connections to appropriate wire.
Secure with wire nuts (supplied).
B. Connect the green wire from the fixture to the power
source green wire.
C. The black wire from the fixture is connected to the
black (L) wire from power source.
D. The white wire from the fixture is connected to the
white (N) wire from power source.
E. Tuck all connections neatly into the junction box.
Step 5. Place fixture base (4) over the gem bar, align
two mounting holes on both sides.

Step 6. Install fixture by securing the base with two
screws (3) (supplied).

Restore power at fuse or circuit breaker box.
For Relamping only-Fig.2
Step 1. . Use “U” shaped spanner tool (8) supplied to remove glass shade (7) by aligning its two spokes with corresponding

holes in the shoulder ring of the glass shade. Turn the spanner tool counter-clockwise to completely unscrew the glass
shade from its base.

Step 2. Remove old LED lamp by turning counter clockwise to unlock it.
Step 3. Insert new LED lamp (6) into the lamp socket (5) and turn it counter clockwise until lamp snaps in place.

Step 4. Re-attached glass shade by using spanner tool to thread it into the base.

Limited Factory Warranty

AFX warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a
period of 3 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or
components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit

1 of 1

8060736 Rev 4