AFX HZS1016218QENSNFSS User Manual

Safety Precautions

Hudson – HZS Series Fluorescent Wall Sconce

Model 218

Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that all wiring shall be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.

Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.

This fixture is designed for use in a 120VAC, 60Hz fused circuit.

Assembly Instructions

1. Preparing for installation-

A. Disconnect electrical power

before installing or servicing
any part of this fixture.

B. Remove shade assemblies (2),

and fixture assembly (6) from
cartons. Separate contents of
hardware bag.

2. Mounting-

A. Attach mounting plate (7) to

junction box (not provided)
with two of the long screws
provided (9)

B. Pull supply wires through the

mounting plate.

C. Twist green (or green and

yellow) wire from fixture with
supply ground and attach to the
green ground screw on the
mounting plate. Tighten ground
screw.

3. Wiring- all wiring must take

place inside junction box.

Caution: Make sure power is off at

fuse or circuit breaker box. Check
power wires for damage or scrapes. If
power supply wires are within three
inches of ballast use wire suitable for at
least 90C (194F). Note: Most dwellings

Limited Factory Warranty
AFX Lighting, Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2
years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover failure due to
improper installation, misuse, mishandling or damage incurred in transit.

Do not use on a dimming circuit. Make sure that the power source
conforms to the requirements of the fixture (see labels on fixture
housing).

To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing. This fixture
is intended to be used for general indoor lighting in dry or damp
locations only.

built before 1985 have supply wire rated to 60C. Consult
a qualified electrician before installing.

A. Using wire connectors, connect white supply

wire to white lamp lead.
Connect black hot supply
wire to black lamp lead.
Do not mix wires. Tuck
all connections neatly into
junction box.

B. Line the holes in the

fixture canopy (6) with the
holes on the mounting
plate (7). Insert supplied
screws(8) into threaded
holes in the mounting pan
and tighten securely.

4. Lamp -Install appropriate

lamp (4). Insert lamp pins into
lamp holder (5) and press
downwards until lamp snaps in
place.

5. Shade -To install shade

assembly, align the two holes
in the top of the shade (2) with
the two threaded studs on top
of the harp (3) and secure with
threaded ball nuts (1).

6. Restore power at fuse or circuit

breaker box.

Page 1 of 1 8060305 rev.3