AFX CFF12122C930ENSN User Manual

CFF Series Euro Style Fluorescent Fixture

4-PIN CFQ LAMPS

SHOWN

Models: 213, 218, 226, 318, 326, 2022, 2032, 2054, 2072

Safety Precautions

Read all safety precautions and installation inst ructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.

It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.

Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.

Assembly Inst ruc t i on s

1. Preparing for installation

A. Disconnect electrical power

before insta lling or servicing any
part of this fixture.

B. To remove diffuser, shift diffuser

(1) to one side and gently remove
diffuser as sho wn .

Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).

To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must b e a s eparate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clear ly marked on the fixture housing.

This fixture is intended to be used for general indoor lighting in dry
or damp locations only.

2. Wiring

All wiring must take place inside ju nction box. Caution: Make sure power is off

at fuse or circuit breaker box. Check power wires for damage or scrapes. If power
supply wires are within three inches of ba lla st use wire suitable for at least 90C
(194F). Note: Most dwellings built before 1985 have supply wire rated to 60C.
Consult a qualified electrician before installing.

A. This unit will not operate properly unless connected to a “grounded” electrical

circuit. Electrical shock, over hea ting, low or no light outp ut, and shortened
lamp life can result if proper grounding is not done. Securely attach green (or
green and yellow) wire to ground supply wire.

B. Using wire connectors (provided), connect white supply wire to white ballast

lead. Connect black hot supply wire to black ballast lead. Do not mix wires.
Pull on each wire lead to make sure connections are secure. Make certain no
bare wires are exposed outside of wire connectors. Note: fixtures with universal voltage power supplies are pre-wired with a
disconnect. Refer to the included guide for using the disconnect.

3. Mounting

A. Mount housi ng (2) to junction box (3 - not provided) with the two #8-32 x 7/8” screws (4 - provided) t hrough keyhole s lots.

4. Installing lamps

A. Compact – 4-pin (5 - not provided) insert lamp pins into lamp holder and press until lamp snaps in place.
B. GU24 – (No t shown) insert lamp pins into lamp holder and rotate until lamp snaps in place.
C. Circle line – (Not shown) insert lamp pins into lamp holder and press until lamp snaps in plac e .

Mounting diffuser

5.

A. Install the round plastic diffuser (1). Bend the diffuser (1) slightly and start to feed the diffuser under the lip on the fixture

housing until it snaps into positio n.

6. Power to the fixture can now be restored

Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions
for a period of 2 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or
components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.

Page 1 of 1 8060754 Rev.2